Bedienungsanleitung Marantz NR1604 (Seite 145 von 168) (Englisch)

513671

145

Zoom out

Zoom in

Vorherige Seite

1/168

Nächste Seite

142

Remote control unit

Inserting the batteries

q Remove the rear lid in the

direction of the arrow and

remove it.

w Load the two batteries properly

as indicated by the marks in the

battery compartment.

R03/AAA

e Put the rear cover back on.

NOTE

•Insert the speciﬁed batteries in the remote control unit.

•Replace the batteries with new ones if the set does not operate

even when the remote control unit is operated close to the unit. (The

supplied batteries are only for verifying operation. Replace them

with new batteries at an early date.)

•When inserting the batteries, be sure to do so in the proper direction,

following the q and w marks in the battery compartment.

•To prevent damage or leakage of battery ﬂuid:

•Do not use a new battery together with an old one.

•Do not use two dierent types of batteries.

•Do not attempt to charge dry batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in

ﬂames.

•Do not keep the battery in a place exposed to direct sunlight or in

places with extremely high temperatures, such as near a heater.

•If the battery ﬂuid should leak, carefully wipe the ﬂuid o the inside

of the battery compartment and insert new batteries.

•Remove the batteries from the remote control unit if it will not be in

use for long periods.

•Used batteries should be disposed of in accordance with the local

regulations regarding battery disposal.

•The remote control unit may function improperly if rechargeable

batteries are used.

Operating range of the remote control unit

Point the remote control unit at the remote sensor when operating it.

30°30°

Approx. 23 ft/7 m

NOTE

•The set may function improperly or the remote control unit may not

operate if the remote control sensor is exposed to direct sunlight,

strong artiﬁcial light from an inverter type ﬂuorescent lamp or

infrared light.

•When using 3D video devices that transmit infrared communication

signals (such as infrared signals etc) between the various units

(such as the monitor, 3D glasses, 3D transmitter unit etc), the

remote control unit may not operate due to interference from those

communication signals. If this occurs, adjust the direction and

distance of the 3D communication for each unit, and check that the

remote control unit operation is not aected by these signals.

Specifying the zone used with the remote

control unit

When the ZONE2 button is pressed, only the MAIN ZONE can be

operated with the remote control unit.

Press and hold ZONE2 and SETUP.

MAIN and ZONE2 button blink.

n To cancel

Press and hold ZONE2 and SETUP.

MAIN and ZONE2 button blink.

Basic instructions

Advanced instructions

InformationInformation

DVD

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz NR1604 Seite 145

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marantz NR1604

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info