Bedienungsanleitung Marantz PM15S1 (Seite 12 von 28) (Englisch)

522804

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

ENGLISH

NAMES AND FUNCTIONS OF PARTS

FRONT PANEL

q POWER ON/OFF Switch

This switch turns power to the PM-15S1 ON and OFF.

When pressed, power is activated and the blue indicator

on the display w lights up. Approximately 8 seconds after

power is activated, audio output is enabled. Pressing the

switch again turns power OFF.

w Display

The display displays the selected input source, volume level

and setting status.

e INPUT SELECTOR Knob

This knob is for selecting the input source to use in play-

back and recording. The selected input source is displayed

on the display w.

r VOLUME Knob

This knob is for setting the volume. The volume level is

displayed on the display w. Turning the knob clockwise

increases the volume, while turning it counterclockwise de-

creases the volume. When turned slowly, the volume can

be fine-adjusted in 0.5 dB steps, whereas when turned

rapidly, volume level changes greatly.

t BASS/TREBLE Knobs

These buttons adjust the bass and treble. Turning them

clockwise increases the respective tone, whereas turning

them counterclockwise decreases the respective tone.

Tone cannot be adjusted while the TONE button o is in

the OFF position, therefore set the button in the ON posi-

tion to control bass and treble from these buttons.

y PHONES Jack

This jack is for connecting headphones with a standard

stereo plug. To listen with headphones, turn speaker out-

put OFF by setting the SPEAKERS button !0 in the OFF

position.

u Infrared Receptor Window

This is the receptor of control signals sent from the included

RC-11PMS1 remote controller. Point the remote controller

towards this window to properly send signals.

i DISPLAY Button

This button turns the display and illumination lamp ON and

OFF.

If the display is out and the VOLUME knob or other control

is operated, the display lights up. It will automatically go

out 3 seconds after the operation has been completed.

o TONE Button

This button turns the bass and treble tone control ON and

OFF. When tone control is ON, the center of the button is

lit a blue color.

!0 SPEAKERS Button

This button turns output to the speakers connected to the

SPEAKER SYSTEMS output terminals on the rear panel

ON and OFF. When speaker output is ON, the center of

the button is lit a blue color. To listen with headphones,

turn speaker output OFF.

!1 ATT. Button

This button attenuates volume with one press of the but-

ton. When pressed, “AT T ” flashes on the display and the

volume is reduced. If pressed again, the mode is canceled

and the original volume level is restored. Attenuation level

is set to –20 dB when the PM-15S1 is shipped from the

factory, but it can be set to either –40 dB or -∞ (mute). For

instructions on how to set attenuation level, see “ATTENU-

ATION (ATT)” on pg. 17.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz PM15S1 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info