Bedienungsanleitung Marantz PS17 (Seite 40 von 44) (Englisch)

522805

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

ENGLISH

OTHER FUNCTIONS

LUMINOUS BUTTONS

The buttons on this remote controller are designed to remain

luminous in dim lighting conditions. If the buttons are no longer

luminous when the remote controller is used in low light, recharge

them by placing it near a fluorescent or other light source for a

sufficient amount of time. This should return the buttons to their

luminous condition.

SETUP

Switch the RC-5 destination or adjust the time interval between

transmissions of macro operations as follows:

1. While pressing the MEMO button ⁄6 , press the OK Cursor button

⁄0. This will switch the remote controller to the Setup mode.

The Setup mode includes the following items, which may be

accessed using the ^ and

v Cursor buttons ⁄0.

• Switch destination (version) (VER)

• Adjust time interval between transmissions of macro

operations(MACRO)

VER: Switches the type of preset codes contained in the remote

controller .

LCD a displays VER, while LCD b displays either USA or REST.

USA means that the CD-R/MD Function button , is set to CD-R.

REST means that the CD-R/MD Function button , is set to MD.

Use the < and > Cursor buttons ⁄0 to select the desired version, then

press the OK Cursor button ⁄0. This will finish the operation and

return the LCD to its original state.

• To cancel the setting, press any button other than the Cursor

buttons ⁄0.

• To continue the setting, press the

v Cursor button ⁄0.

Note:

Codes that have been programmed will not be erased even if the

VER setting is changed, however the NAME indicator displays

associated with the Jog Dial command will be changed. Also, the

Jog Dial commands for CD-R/MD functions that are contained

within macros will also change.

MACRO: Adjusts the time interval between transmissions of

macro operations

When the

v Cursor button ⁄0 is pressed, LCD a displays MACRO,

while LCD b displays STEP.

One square (7) in LCD c is equivalent to an interval of 0.5 seconds,

allowing intervals of up to 5 seconds to be set. The remote controller

is set at the factory with an interval of 1 second, as indicated by

(77&&&&&&&&). Adjust the interval between transmission of

operation codes using the ^ and

v Cursor buttons ⁄0, then press the

OK Cursor button ⁄0.

• To cancel the setting, press any button other than the Cursor

button ⁄0.

• To continue the setting, press the

v Cursor buttons ⁄0.

GUIDE

MUTE

VOL

DVD

CD-R/MD

DSS TV VCR

TUNER

TAPE

PHONO

AUTO

SRS

6.1

5ch-ST.

Dolby H

P-DIRE.

2CH OSD SLEEP

AMP

CLEAR

MEMO

BATTERY LIFE

• New batteries will last about 6 months assuming an average of 30

uses per day.

Note:

The batteries shipped with the remote controller are for the

purpose of checking function and may not last as long as new

batteries.

NUMBER OF LEARNABLE CODES

The remote controller (RC-17PS) uses 128-Kbyte large-capacity non-

volatile memory (EEPROM) and is therefore capable of learning a

maximum of 330 remote control codes. This applies only to Philips

RC-5 remote programming language codes, however, and

depending on the type of other codes that are programmed, the

remote controller can learn less than 330 codes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz PS17 Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info