User Guide
52
Frequently Asked Questions
Can I program a device button to execute more than one
command?
No, you can’t. However, you can program a button on the macro side
of the remote to execute a sequence of commands (see page 24).
How do I program source switching?
See “Programming device items” on page 16.
How can I edit, label or delete buttons on home panels?
You can do this via the Device menu items. All changes you make
to these items are automatically updated in the Home menu.
How do I reset the RC5000i?
Normally, you never have to reset the RC5000i. However, if the
RC5000i’s display freezes or if you notice unusual behavior, you
might need to reset. You will not lose any saved programmed
commands or macros.
n Carefully press the reset button on the back of the RC5000i with
a paperclip or sharp pencil.
The RC5000i restarts and beeps to indicate it is ready for use.
Can I revert to the original configuration?
Yes, by using a Windows PC with RC5000 Setup. Once RC5000
Setup is installed, open a ccf titled New_RC5000i_Default in
C/:Program Files/RC5000/Samples. Downloading this configuration
to your RC5000i will restore your RC5000i to its factory state.
How can I free up more memory?
The default configuration of the RC5000i takes up almost 1
megabyte of memory leaving approximately 200kb available for
your programming. If you do not need the library of Marantz IR
codes and the demonstrations of macro programming pre-
programmed in the factory configuration, you can free up over
