769600
28
Zoom out
Zoom in
Vorherige Seite
1/42
Nächste Seite
Troubleshooting
If a problem should arise, first check the following.
1. Are the connections correct?
2. Is the unit being operated as described in the owner’s manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.
nPower does not turn on / Power is turned off
Symptom Cause / Solution Page
Power is not turned on. 0Check whether the power plug is correctly inserted into the power outlet. 10
0This unit is in standby mode. Press the X CD button on the remote control. 11
Power automatically turns off. 0The Auto Standby mode is set. The Auto Standby mode switches the unit to standby mode when the unit is not operated for
approximately 30 minutes. To disable Auto Standby mode, set “Auto Standby” on the menu to “Off”.
24
The power turns off and the power
indicator blinks in red when a USB
memory device is connected.
0The connected USB memory device is not supported. Please use a USB memory device with an operating current that is less than
1A.
0The device requires more power than can be supplied by this unit via USB. Press X on this unit to turn the power off, remove the
USB memory device and then turn the power on again.
nOperations cannot be performed through the remote control unit
Symptom Cause / Solution Page
Operations cannot be performed
through the remote control unit.
0Batteries are worn out. Replace with new batteries. 2
0Operate the remote control unit within a distance of about 7 m from this unit and at an angle of within 30°. 2
0Remove any obstacle between this unit and the remote control unit.
0Insert the batteries in the proper direction, checking the q and w marks. 2
0The unit’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). Move the unit to
a place in which the remote control sensor will not be exposed to strong light.
0When using a 3D video device, the remote control unit of this unit may not function due to effects of infrared communications
between units (such as TV and glasses for 3D viewing). In this case, adjust the direction of units with the 3D communications
function and their distance to ensure they do not affect operations from the remote control unit of this unit.
0Press the REMOTE MODE CD button to switch the remote control operating mode to “CD”. 7
0When using this unit independently, set the switch to “INTERNAL”. 10
ENGLISH
27
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Marantz SA-12 SE wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Marantz SA-12 SE

Marantz SA-12 SE Bedienungsanleitung - Deutsch - 42 seiten

Marantz SA-12 SE Bedienungsanleitung - Holländisch - 42 seiten

Marantz SA-12 SE Bedienungsanleitung - Französisch - 42 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info