Bedienungsanleitung Marantz SR-9200 (Seite 5 von 54) (Englisch)

6610

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

ENGLISH

FOREWORD

This section must be read before any connection is made to the mains

supply.

WARNINGS

Do not expose the equipment to rain or moisture.

Do not remove the cover from the equipment.

Do not push anything inside the equipment through the

ventilation holes.

Do not handle the mains lead with wet hands.

EQUIPMENT MAINS WORKING SETTING

Your Marantz product has been prepared to comply with the

household power and safety requirements that exist in your area.

SR9200 can be powered by 230 V AC only.

IMPORTANT: (FOR UK VERSION ONLY)

This apparatus is fitted with an approved moulded 13 Amp plug.

To change a fuse in this type of plug proceed as follows:

1. Remove fuse cover and fuse.

2. Fix new fuse which should be a BS1362 13A, A.S.T.A. or BSI

approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut

off and an appropriate plug fitted in its place.

If the mains plug contains a fuse, this should have a value of 13A. If a

plug without a fuse is used, the fuse at the distribution board should

not be greater than 5A.

Note:

• The severed plug must be destroyed to avoid a possible shock

hazard should it be inserted into a 13A socket elsewhere.

HOW TO CONNECT A PLUG

The wires in this mains lead are coloured in accordance with following

code: – green - and - yellow : earth

– blue : neutral

– brown : live

As the coloured of the wires in the mains lead of this apparatus may

not correspond with the coloured makings identifying the terminals in

your plug, proceed as follows:

– the wire which is coloured green and yellow must be connected to

the terminal in the plug which is marked with the letter E or by the

earth symbol , or coloured green or green and yellow.

– the wire which is coloured blue must be connected to the terminal

which is marked with the letter N or coloured black.

– the wire which is coloured brown must be connected to the terminal

which is marked with the letter L or coloured red.

Before replacing the plug cover, make certain that the cord grip is

clamped over the sheath of lead – not simply over the two wires.

Recording and playback of any material may require consent. For

further information refer to the following:

- Copyright Act 1956

- Dramatic and Musical Performers Act 1958

- Performers Protection Acts 1963 and 1972

- any subsequent statutory enactments and orders

ABOUT THIS USER GUIDE

Refer to the figures on page 2 of this user guide. The numbers on the

figurescorrespond to those in the text. All references to the

connections and controls that are printed in BOLD type are as they

appear on the unit.

PRECAUTIONS

The following precautions should be taken when operating the

equipment.

GENERAL PRECAUTIONS

When siting the equipment ensure that:

- the ventilation holes are not covered;

- air is allowed to circulate freely around the equipment

- it is on a vibration free-surface;

- it will not be exposed to interference from an external source;

- it will not be exposed to excessive heat, cold, moisture or dust;

- it will not be exposed to direct sunlight;

- it will not be exposed to electrostatic discharges

Never place heavy objects on the equipment.

If a foreign body or water does enter the equipment, contact your

nearest dealer or service centre.

Do not pull out the plug by pulling on the mains lead, hold the plug.

It is advisable when leaving the house, or during a thunderstorm, to

disconnect the equipment from the mains supply.

PRECAUTIONS IN CONNECTION

• Be sure to unplug the power cable from the AC outlet or turn off the

POWER/STANDBY switch before proceeding with any connection.

• Connect one cable at a time observing the “input” and “output”.

This will avoid any cross connection between channels and signal

inputs and outputs.

• Insert the plugs securely. Incomplete connection may result in

noise.

• Prior to connecting other audio and video equipment to the SR9200,

please read their owner’s manuals.

INSTALLATION

If this unit or another electronic device incorporating a microcomputer

is used at the same time with the tuner or television, picture

disturbance or noise may occur. In such a case, install the unit

according to the following guide points.

• Separate the unit as far as possible from the tuner or television.

• Place the antenna wire for the tuner or TV apart from the power

cable and audio and video connection cables of this unit.

• Since the phenomenon is likely to occur when using an indoor

antenna and/or 300-ohm feeder wire, we recommend using an

outdoor antenna and 75-ohm coaxial cable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz SR-9200 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marantz SR-9200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info