11
ENGLISH
‹2 AUDIO buttons
(When DVD mode is selected)
This button is used to select one of the audio
language.
‹3 TREBLE +/- buttons
These buttons are used to adjust the tone control of
high frequency sound for left and right speaker.
‹4 SOURCE button
These buttons are used to switch the source of your
A/V Receiver / amplifer. Each time a source button is
pressed, the remote controller changes to the source
which was pressed.
This remote controller can control 12 types of
equipment. To change the A/V Receiver / amplifi er
source, press this button twice within two seconds.
The signal is sent when it is pressed the second
time.
Notes:
• Select the AMP as the source to use this remote
controller with the unit.
• In the case of the SR4002 or SR5002, the MD button
cannot be used.
‹5 Infrared Transmitter and Learning
Sensor
This transmitter emits infrared light. Press the buttons
while pointing the transmitter towards the infrared
receiver window of the unit or other AV equipment.
Be sure to also point towards other remote controllers
when using the learning function.
¤6 VOLUME +/- buttons
This button is used to adjust the volume for the
amplifi er and television.
Note:
Set the AMP mode to use this button with the unit.
¤7 M-SPKR button (SR5002 only)
(When AMP mode is selected)
This button is used to turn on and off multi speaker.
¤8 MENU button
(When AMP mode is selected)
This button is used to call up the SETUP MAIN
MENU of the unit.
¤9 1,
2,
3,
4
(CURSOR) / ENTER buttons
These buttons are used when controlling the cursor
of the unit, DVD or other AV equipment.
‹0 EXIT button
(When AMP mode is selected)
This button is used to cancel setting in the setup
menu.
‹1 SUBTITLE/ATT. button
(When AMP mode is selected)
When the input signal is too high and the voice
distorts even by throttling the unit VOLUME control,
turn on this function.
“ATT ” is indicated when this function is activated.
The input level reduced. Attenuator is invalid for the
output signal of “REC OUT”.
Note:
This function is unavailable while the digital input is
selected.
¤0 P.DIRECT button
When this button is pressed, the tone control circuit
is bypassed.
¤1 BAND/LIP SYNC/INPUT button
(When TUNER mode is selected)
This button is used to select a radio band.
(When AMP mode is selected)
This button is used to select LIP SYNC mode.
(When TV mode is selected)
This button is used to select monitor input.
¤2 T.MODE button
(When TUNER mode is selected)
This button is used to select auto stereo mode or
mono mode when the FM band is selected.
The “AUTO” indicator lights in the auto stereo mode.
¤3 P.SCAN button
(When TUNER mode is selected)
This button is used to start preset scan.
¤4 MEMO/HT-EQ button
This button is used to store setting to memory or
program a source.
(When AMP mode is selected)
This button is used to turn on or off HT(Home
Theater)-EQ mode. This mode compensates for the
audio portion of a movie sounding “bright”.
When this button is pressed, “EQ” indicator light up.
¤5 MUTE button
This button is used to mute the audio for the amplifi er
and television.
Note:
Set the AMP mode to use this button with the unit.
SR4002-5002U DFU_01_E1_2.indd 11SR4002-5002U DFU_01_E1_2.indd 11 07.7.9 2:46:48 PM07.7.9 2:46:48 PM
