Bedienungsanleitung Marantz SR5005 (Seite 13 von 92) (Englisch)

453908

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

Basic version Advanced version Information

ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA

Simple version

ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA

About setup microphone placement

• Measurements are performed by placing the setup microphone

successively at multiple positions throughout the entire listening

area, as shown in GExample qH. For best results, we recommend

you measure in six positions, as shown in the illustration (up to six

positions).

• Even if the listening environment is small as shown in GExample wH,

measuring at multiple points throughout the listening environment

results in more effective correction.

FL SW C FR

SBL SBR

FL SW C FR

SBL SBR

(

: Measuring positions)

GExample qH GExample wH

(

: Measuring positions)

FL Front speaker (L) SL Surround speaker (L)

FR Front speaker (R) SR Surround speaker (R)

C Center speaker SBL Surround back speaker (L)

SW Subwoofer SBR Surround back speaker (R)

About the main listening position (*M)

The main listening position is the position where listeners would

normally sit or where one would normally sit alone within the listening

environment. Before starting Audyssey Auto Setup, place the setup

microphone in the main listening position. Audyssey MultEQ

uses

the measurements from this position to calculate speaker distance,

level, polarity, and the optimum crossover value for the subwoofer.

The “Simple version” section provides the speaker installation, connection, and setup methods for the 7.1-channel system with surround back speakers.

For the installing, connecting, and setup methods of speakers other than the 7.1-channel system (with surround back speakers), see page 32.

Set up speakers (Audyssey

Auto Setup)

Set up the remote control unit

n Set up the operation mode

Press AMP to set the remote control unit to amplier

operation mode.

Press AMP

Set up the microphone

Mount the setup microphone on a tripod or stand

and place it in the main listening position.

When placing the setup microphone, adjust the height of the

sound receptor to the level of the listener’s ear.

Sound receptor

Setup

microphone

NOTE

• Do not hold the setup microphone in your hand during

measurements.

• Avoid placing the setup microphone close to a seat back or wall as

sound reﬂections may give inaccurate results.

Set up the subwoofer

If using a subwoofer capable of the following

adjustments, set up the subwoofer as shown below.

n When using a subwoofer with a direct mode

Set the direct mode to “On” and disable the volume adjustment

and crossover frequency setting.

n When using a subwoofer without a direct mode

Make the following settings:

• Volume : “12 o’clock position”

• Crossover frequency :

“Maximum/Highest Frequency”

• Low pass ﬁlter : “Off”

• Standby mode : “Off”

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz SR5005 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marantz SR5005

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info