Bedienungsanleitung Marantz SR6003 (Seite 80 von 90) (Englisch)

61897

Zoom out

Zoom in

Vorherige Seite

1/90

Nächste Seite

ENGLISH

BASIC

CONNECTIONS

BASIC OPERATION

ADVANCED

CONNECTIONS

SETUP

ADVANCED

OPERATION

TROUBLESHOOTING

OTHERS

NAMES AND

FUNCTION

TROUBLESHOOTING

PROTECTIVE FEATURE

In some cases, the STANDBY indicator may

blink slowly, twice per second. In this case, turn

off the unit, unplug the power cord, and check the

following points.

• Make sure the speaker cables are not reversed

and connected to the wrong sides (+ and -) on the

unit.

• Make sure the speaker cables connected to the

unit are not shorted. (Check both the unit end and

the speaker end.)

• Make sure the volume does not exceed the level

that the unit is capable of producing.

• When using the unit in a rack or other enclosed

space, heat may build up inside the unit and

cause a ﬁ re. When installing the unit, be sure

to leave sufﬁ cient space between the top, back

and both sides of the unit and walls or other AV

components to prevent the internal temperature

from rising.

After checking these points, plug in the power cord

and use the remote controller to turn on the unit.

Turn down the volume before resuming playback.

Confirm that there are no problems with the

speaker connections and playback performance.

If this symptom recurs, request service at your

nearest service center.

In rare instances, the unit may enter standby mode

and the STANDBY indicator may blink rapidly, 8

times per second. In this case, unplug the power

cord and request service at your nearest service

center.

SURROUND

MODE

PURE

DIRECT

EXIT CLEAR

FRONT KEY (BUTTON) LOCK OF THE UNIT

To lock all front panel buttons (except the POWER

ON/OFF button) and the INPUT SELECTER and

VOLUME knobs, hold the PURE DIRECT and EXIT

buttons on the front panel simultaneously for at least

3 seconds. At this time, “F-KEY LOCK!” is displayed.

To unlock the controls, press the same buttons again

simultaneously for at least 3 seconds. At this time,

“F-KEY UNLOCK” is displayed, and the buttons are

released.

GENERAL MALFUNCTION

If the equipment malfunctions, this may be because

an electrostatic discharge or AC line interference has

corrupted the information in the equipment memory

circuits. Therefore:

- disconnect the plug from the AC line supply

- after waiting at least three minutes, reconnect

the plug to the AC line supply

- re-attempt to operate the equipment

Memory backup

• In case a power outage occurs or the power

cord is accidentally unplugged, this unit is

equipped with a backup function to prevent

memory data such as the preset memory

from being erased.

HOW TO RESET THE UNIT

Should the operation or display seem to be abnormal,

reset the unit with the following procedure.

This unit is turned on, press and hold the SURROUND

MODE + CLEAR buttons simultaneously for 3

seconds or more.

Remember that the procedure will reset the settings

of the function selector, Surround mode, delay time,

TUNER PRESET etc., to their initial settings.

XM SATELLITE RADIO

If a problem should arise, ﬁ rst check the following.

1. Are the connections correct?

2. Have you operated the receiver according to the operating instructions?

3. Are the speakers and other components operating properIy?

If this unit is not operating properly, Check the items listed in the table beIow. Should the problem persist, there

may be a malfunction. Disconnect the power immediately and contact your store of purchase.

SYMPTOM CAUSE REMEDY

“TUNER” is displayed. The XM Mini-Tuner and this unit are not

properly connected.

Check that the units are properly

connected.

“ANTENNA” is displayed. The XM antenna is not properly connected

to the Mini-Tuner Dock.

Check that the antenna is properly

connected. Also, check the antenna cable

for damage.

“NO SIGNAL” is displayed. The Signal cannot be received. Reposition your XM antenna.

Receiving only channels 0 and 1. The XM Mini-Tuner is not activated. Contact XM Satellite Radio.

(See page 53)

“UPGRADE TUNER” is displayed. The connected XM CNP-1000 is

incompatible.

Upgrade the XM CNP-1000 to the XM

Mini-Tuner.

Report the model of the AV receiver and

the ID number of the CNP-1000 to XM

Listener Care. (See page 53)

SIRIUS SATELLITE RADIO

SYMPTOM CAUSE REMEDY

“TUNER ERR” is displayed. SiriusConnect

tuner is not properly

connected.

Check the 8pin mini DIN cable and AC

adapter connection are correct.

“ANTENNA” is displayed Antenna is not properly connected. Check the antenna cable connection is

correct.

“ACQUIRING” is displayed. The signal cannot be received. Reposition your SiriusConnect

tuner

and antenna.

“CALL SIRIUS” is displayed You have not subscribed for the selected

channel.

Call SIRIUS if you want to subscribe.

(See page 58)

“FIRM UPDT” is displayed SiriusConnect

is updating software. Wait until the updating is complete.

SR6003_U_01_ENG 4_4.indd 77SR6003_U_01_ENG 4_4.indd 77 08.8.1 1:08:47 PM08.8.1 1:08:47 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz SR6003 Seite 80

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marantz SR6003

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info