Bedienungsanleitung Marantz SR6005 (Seite 96 von 104) (Englisch)

453909

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed.

When the microprocessor is reset, all the settings are reset to their default values.

Various setting details can be saved and reset on this device. If setting details are saved before returning

to the default values, after returning to the default settings, setting details can be returned to the same

values as before returning to the defaults.

AUTO AUTOBAND

ON/STANDBY ENTER

SURR. MODE

When the power is ON, press and hold BAND and ENTER for more than 3 seconds.

After “MEMORY SAVING” is shown on the display, “COMPLETE”is shown to inform you that the

settings have been saved.

Turn off the power using ON/STANDBY.

Press ON/STANDBY while simultaneously pressing SURROUND MODE and AUTO.

Once the display starts ashing at intervals of about 1 second, release the two

buttons.

Press and hold BAND and MENU for more than 3 seconds.

After “MEMORY LOAD” is shown on the display, “COMPLETE” is shown to inform you that the

settings have returned to those saved in step 1.

• To return all of the settings to the default values, perform steps 2 to 4 without performing step 1.

• If in step 3 the display does not ﬂash at intervals of about 1 second, start over from step 1.

GiPodH

Symptom Cause/Solution Page

iPod cannot be

played.

• Check the iPod connections.

• Switch the input source to “USB”.

• Incompatible iPod types cannot be played back.

“Connection Error”

is displayed.

• Unable to communicate properly. Turn off the power to this unit,

disconnect the iPod and then reconnect it.

–

“Not Support” is

displayed.

• The iPod connected to the unit is not compatible. Please make

sure the iPod you are connecting is compatible.

• The software version of the connected iPod is an old one. Please

update to the latest version.

–

“Connection Error”

is displayed.

• The iPod is not responding. Turn off the power to this unit,

disconnect the iPod and then reconnect it.

–

When an iPod is

connected, “No

Connection” is

displayed.

• “No Connection” may display if you connect an iPod that has

only a small amount of charge remaining in its battery to this unit.

Should this occur, charge the iPod before connecting it to this unit.

–

GM-XPortH

Symptom Cause/Solution Page

Audio is not output

when a wireless

receiver (RX101 is

connected).

• Check that the Bluetooth device and Wireless receiver (RX101)

are correctly paired.

–

GRemote control unitH

Symptom Cause/Solution Page

The set cannot be

operated with the

remote control unit.

• Batteries are worn out. Replace with new batteries.

• Operate the remote control unit within a distance of about 23 ft /

7 m from this unit and at an angle of within 30°.

• Remove any obstacle between this unit and the remote control

unit.

• Insert the batteries in the proper direction, checking the q and

w marks.

• The set’s remote control sensor is exposed to strong light (direct

sunlight, inverter type ﬂuorescent bulb light, etc.). Move the set

to a place in which the remote control sensor will not be exposed

to strong light.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz SR6005 Seite 96

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marantz SR6005

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info