581183

Mares Matrix Seite 15

15
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
15
3.3.1.3 STOP SUMMARY TABLE
The stop summary table lists each individual
stop in depth and duration, including safety,
deco and deep stops. This table does not
appear as long as you are in a no deco dive
without deep stop requirement.
This table is especially useful during
decompression dives since it breaks down the
entire ascent into each individual stop.
To call up the stop summary table, press the
bottom left button.
The stop summary table has an 8-second
time-out, after which the screen automatically
reverts to the default computer display. You
can exit the stop summary table before the 8
seconds are passed by pressing the top left
button.
NOTE
In the event of an alarm, Matrix
automatically switches back to the default
computer display.
3.4 AFTER THE DIVE
Upon returning to the surface, Matrix first
goes into the so-called surfacing mode. This
mode allows you to resume your dive after a
brief period of orientation. The screen shows
a 3-minute countdown, a profile of the dive,
your maximum depth and the dive time. During
surfacing mode you can call up the compass by
pressing and holding the top left button.
If you submerge again before the 3-minute
countdown is over, the dive time will resume
from where it left off, including the time spent
on the surface. If you do not submerge before
the end of the countdown, Matrix considers the
dive finished, records the data to the logbook
and reverts to the so-called post-dive mode.
The post-dive screen shows the following
information:
- The remaining desaturation time (DESAT):
this is calculated by the decompression
model in the computer. Any dive started
while there is remaining desaturation on
your computer is considered a repetitive
dive, meaning that Matrix accounts for the
pre-existing nitrogen load in your body.
- The no-fly time (NO
): this is the time
during which an exposure to the reduced
pressure inside the cabin of an airplane
could cause decompression sickness. Matrix
employs, as recommended by NOAA, DAN
and other agencies, a standard 12-hour
(no-deco non-repetitive dives) or 24-hour
(deco and/or repetitive dives) countdown.
Hence you may find a situation in which the
desaturation time is shorter than the no-fly
time. This is simply the consequence of the
desaturation time being calculated by the
algorithm based on the actual dive profile,
while the no-fly time is an accepted standard
in the diving industry. Since the real effect of
flying after diving has never been fully
investigated, this approach fits with our
philosophy.
WARNING
Flying while Matrix displays NO
can
result in serious injury or death.
- The surface interval (SURF): this is displayed
from the moment the dive is closed (3
minutes after surfacing) for as long as there
is remaining desaturation or no-fly time on
the computer.
- In case of a dive violation, the corresponding
symbol (
, ) is shown next to the surface
interval.
In addition, the left bar graph shows the
calculated nitrogen load in the leading tissue.
You can use this to gauge your progress
in getting rid of nitrogen as the surface
interval grows. Matrix continues to perform
decompression-related calculations (nitrogen
release), for as long as there is desaturation
time left.
During post-dive mode you can revert to the
regular watch display by pressing the top left
button. You can return to the post-dive screen
again by pressing the top left button.
From the post-dive screen you can also jump
directly to the log of the last dive by pressing
and holding the top right button.
3.5 DIVING WITH MORE THAN ONE
GAS MIXTURE
WARNING
- Diving with more than one gas mixture
represents a much higher risk than
diving with a single gas mixture, and
mistakes by the diver may lead to
serious injury or death.
- During dives with more than one gas
mixture, always make sure you are
breathing from the tank that you intend
to breathe from. Breathing from a high
oxygen concentration mix at the wrong
depth can kill you instantly.
- Mark all your regulators and tanks so
that you cannot confuse them under any
circumstance.
- Before each dive and after changing
a tank, ensure that each gas mixture
is set to the correct value for the
corresponding tank.
Matrix enables you to use up to three gas
mixtures during the dive (air and Nitrox
only). The three mixtures are labeled G1, G2
and G3 and must be in ascending order of
oxygen content, i.e. G1 has the lowest oxygen
concentration, G2 an intermediate value, and
G3 has the highest oxygen concentration of the
three. If you are diving with only two mixtures,
you will be utilizing tanks G1 and G2.
WARNING
It is not possible to switch to a gas at a
depth at which the oxygen partial pressure
for that gas is greater than the set
maximum value.
… 15 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

mares-matrix

Suche zurücksetzen

  • Meine Uhr schalten sich nicht ein. Ist voll geladen. Wie schalte ich die Uhr ein?
    Eingereicht am 8-2-2020 16:26

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mares Matrix wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Mares Matrix

Mares Matrix Bedienungsanleitung - Deutsch - 20 seiten

Mares Matrix Bedienungsanleitung - Holländisch - 20 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info