Bedienungsanleitung Marmitek DoorPhone 124 (Seite 15 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

494283

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

DOORPHONE 120™

• Battery life; in case of power cut, the batteries of the door unit should last approximately

5-6 weeks. This depends on the use of the system. When the batteries are low, the symbol

shall appear on the display and a signal will be heard. Pressing the on/off button (8) will

stop the signal temporarily, but the symbol

will remain displayed.

• Outside temperature; The outside temperature is displayed on the handset. During the

installation of the door unit, the temperature will not be displayed on the handset, but after

the installation is done, the temperature will appear.

8. INTERCOM

This function applies only with the use of 2 or more handsets. In that case it is necessary that

all handsets are set to the same channel and have the same ID code (see ‘Cloning’).

Calling handset Receiving handset(s)

Press on the ‘Call’ button (10) and you will hear the

ringtone, also the symbol

will appear.

When receiving the call, the ringtone will be heard.

Ringtone stops when the call in answered, you may speak

now. If no one answers, the ringtone will stop after 20

seconds.

Press on the speech button (9) to answer the call. The

ringtone will stop and the symbol

will appear, you can

now start to converse. You can also choose to press the

on/off button (8) to ignore the call.

The conversation time is limited to 30 seconds, when

reaching the end of this limit you will hear a beep. You can

extend this time limit by another 30 seconds by pressing

the speech button (9). There is no limit to the amount of

times you can extend the time limit.

Conversation period cannot be extended with the receiving

handset.

End the conversation by pressing on the on/off button (8). End the conversation by pressing on the on/off button (8).

Calling selectively with a handset is not possible. When a handset makes a call, all other

handsets (that are set to the same channel) will ring and can answer the call. The ﬁrst handset

that answers the call by pressing the speech button (9) will block all other handsets, and these

will not be able to receive the call.

Beware! When two handsets are in conversation, it will not be possible to receive a call from

the door unit.

9. FREQUENTLY ASKED QUESTIONS

Handset and door unit are not communicating

• The ID code is not set correctly. Repeat the pairing procedure.

• The channels are not synchronised. Set the handset and the door unit on the same channel

and then repeat the pairing procedure.

• The batteries are low. Replace the door unit batteries or charge the handset.

• The yellow log-on dipswitch (7) on the door unit is still on ‘Pairing’. Repeat the pairing

procedure and set the switch to the normal position.

20194_20100216_UG_Doorphone120.i15 15 12-3-2010 9:52:47

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marmitek DoorPhone 124 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info