Bedienungsanleitung Marshall JH-1 Jackhammer (Seite 3 von 5) (Englisch)

442781

Zoom out

Zoom in

Vorherige Seite

1/5

Nächste Seite

Introduction

Since we began in 1962, the Marshall name has been synonymous

with high quality distortion tones. Initially the way to get classic

Marshall distortion was to naturally overdrive one of our valve amps by

cranking it up to full volume. As time went by our Master Volume

heads allowed the generation of more extreme levels of distortion as

the pre-amps valves were driven into overdrive. Our first generation

pedals simulated these various valve amp type distortions in

convenient, cost effective stomp boxes.

The Jackhammer is the next step on from previous Marshall distortion

pedals. It contains our most extreme distortion levels to date,

combined with a Contour section that allows you to not only scoop out

the mids, but also choose the frequencies at which the scoop occurs.

This means that you can tailor your sound to your own individual

requirements.

Although the Jackhammer has more aggresion and gain than any other

Marshall pedal, we never forget our heritage. The sounds contained are

always natural and realistic, like a super high-gain valve head pushed

to the max.

The Jackhammer features two modes; Overdrive and Distortion.

Overdrive delivers an open crunch for that classic Marshall roar,

whereas Distortion gives you a smooth and singing compressed high

gain tone.

The Jackhammer features a passive bypass for the main signal path, to

ensure complete tonal integrity and has a quality of tone matched only

by its versatility.

Here follows a complete run down of the Jackhammer’s features for

your information. We have also enclosed a number of suggested

settings to help guide you. It should be remembered that these are

only suggested settings and you should experiment as much as

possible.

If you take the time to explore the many different overdrive and

distortion characters of the Jackhammer, you won’t be disappointed.

Features

1. Jack Socket

This is the output of the Jackhammer and is for connection to the

amplifier or to another effects pedal.

2. Mode

Allows for selection of the Jackhammer’s two modes; Overdrive and

Distortion. Overdrive gives you traditional Marshall open roar,

similar to JCM 800 style Master Volume models with more bite and

dynamics. Distortion Mode delivers a more saturated high gain

compressed tone, similar to the high gain channels on JCM 2000

models.

3. Gain

This increases the amount of distortion, taking you from vintage

Always use good quality shielded leads.

Always use 9V regulated DC supply with centre negative.

Although it may seem obvious the first action in achieving a good

effected sound (be it duration / compression etc.) is to find the

perfect bypassed sound. This will then allow the correct level to be

set with the effect unit to allow a cut or boost in volume and a

realistic tone.

On clean channels it is advisable to set the gain (or volume) to a

setting of no less than one quarter maximum so as not to get

unrealistic results due to any volume dependent tonal shaping on

the amplifier preamp.

Setting Up

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marshall JH-1 Jackhammer Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info