4
INHOUD
Veiligheid 2
Wegwerpen van verpakkingsmateriaal 4
Het gebruik 5
Reiniging van de binnenkant 5
Ingebruikname 5
Temperatuurinstelling 5
Koelen van levensmiddelen 5
Het invriezen van verse levensmiddelen, 5
Bewaren van diepvriesproducten 5
Het ontdooien van diepvriesproducten 6
IJslaatjes 6
Verplaatsbare platen 6
Het verplaatsen van deurvakken 6
Tips 6
Koelen tips 6
Invriezen tips 6
Diepvriezen tips 7
Diepvriezkalender 7
Onderhoud 7
Schoonmaken 7
Geprolongeerde stilstand 7
Vervangen van de lamp 8
Het ontdooien 8
Als er iets niet in orde is 8
Technische gegevens 9
Installatie 9
Plaats van opstelling 9
Muur-afstandshouders 9
Elektrische aansluiting 9
Het wijzigen van de deurdraairichting 10
Garantiebepalingen en Service 11
WEGWERPEN VAN VERPAKKINGSMATERIAAL
Het verpakkingsmateriaal van onze grote elek-
trische huishoudelijke apparaten kan met uitzonde-
ring van houten onderdelen, gerecycled worden en
dus bij het kringloopafval worden gezet.
Wij raden u aan om:
• Papier, karton en golfkarton in de speciale
papierbakken te werpen.
• Plastic verpakkingsmateriaal in de speciaal daar-
voor bestemde plastic-containers te gooien.
Indien dit soort bakken in uw buurt nog niet
voorkomen mag u het materiaal aan de vuilnis-
man meegeven.
Als verpakkingsmateriaal gebruiken wij slechts recy-
cleerbare kunststoffen, zoals bijv.:
In de voorbeelden staat:
PE voor Polyethyleen** 02 = ^ PE-HD;
04 = ^ PE-LD
PP voor Polypropyleen
PS voor Polystyrol
PLASTIC BESTANDDELEN
Om er gemakkelijker achter te komen hoe u het
materiaal van dit apparaat moet wegwerpen en /of
recycleren zijn er op verschillende punten herken-
bare symbolen op aangebracht.
17
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.
Appliance positioned under overhanging kitchen
wall units (see Fig. A).
Appliance positioned without overhanging kitchen
wall units (see Fig. B).
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow accu-
rate levelling of the appliance.
CUSTOMER SERVICE AND SPARE PARTS
If the appliance is not functioning properly, check
that:
• the plug is firmly in the wall socket and the
mains power switch is on;
• there is an electricity supply (find out by plugging
in another appliance);
• the thermostat knob is in the correct position.
• If there are water drops on the bottom of the
cabinet, check that the defrost water drain open-
ing is not obstructed (see “Defrosting” section).
• If your appliance is still not working properly after
making the above checks, contact the nearest
service centre.
To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found on the guar-
antee certificate or on the rating plate located inside
the appliance, on the bottom left-hand side.
It is important to periodically clean the defrost
water drain hole in the middle of the refrigerator
compartment channel to prevent the water over-
flowing and dripping onto the food inside. Use
the special cleaner provided, which you will find
already inserted into the drain hole.
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with a plastic scraper, whenever the thick-
ness of the frost exceeds 4 mm. During this opera-
tion it is not necessary to switch off the power sup-
ply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried
out as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting;
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;
3. leave the door open.
4. when defrosting is completed, dry the interior
thoroughly; and refit the plug;
5. turn the thermostat knob back to the required
setting or replace the plug in the power socket.
6. After two or three hours, reload the previously
removed food into the compartment.
Important:
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
Do not use a maechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe stor-
age life.