Bedienungsanleitung master DH 44 INOX (Seite 7 von 12) (Deutsch, Englisch)

588472

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

HUMIDITY GAUGE

Positioned on the front of the machine. It has a graduated

scale from a minimum of 80% to a maximum of 20% of

relative humidity to be obtained in the room (Fig. 4).

REMOTE HYGROSTAT

CONNECTION

For remote humidistat connection (Fig. 5), remove the

cover connected to the dehumidier and connect the

remote humidistat (optional). For correct dehumidier

operation, completely rotate the knob of the humidistat

on the control panel to the max level and set the desired

humidity on the remote humidistat.

HOUR COUNTER

The hour counter is positioned on the front of the machine

and indicates the number of hours the appliance has

worked (Fig. 6).

FIRST IGNITION

Before starting the appliance it must have been in an

upright position (the normal working position) for at least

eight hours.

Failure to observe this instruction could cause irreparable

damage to the compressor.

After eight hours the dehumidier can be plugged into a

220-240V single-phase grounded socket. The “POWER”

red led must switched on to shows that is correctly

powered. If the “WORKING” led is off, turn the humidity

gauge knob in a clockwise direction until it comes on.

The “DEFROST” led will also come on and after about 5

minutes, the dehumidier starts. If the green “FULL” led

is on, the dehumidiers doesn’t start. The tank must be

emptied [if present].

IF THE DEHUMIDIFIER DOES

NOT START OR DOES NOT

DEHUMIDIFY

First of all check the red “POWER” led is on. this shows

that it is correctly powered. Otherwise check if the plug

is correctly connected to the energy supply and if power

reach the appliance. If after these controls the light

remains off, take the appliance to the retailer where it was

purchased.

Check the green “FULL” led is off and check the tank is

empty [if present].

Check the red “WORKING” led is on, this shows the

humidity gauge required to be in function. When the

appliance starts after a pause because the set humidity

level has been reached or because the tank has been

emptied [if present], the “DEFROST” led will come on,

besides the two “POWER” and “WORKING” leds. They

will remain on for about 3 minutes when only the fan will

be working and the compressor will be off.

This cycle is repeated about every 45 minutes to defrost

the coil (evaporator). If the “DEFROST” led remains on for

more than ten minutes take the dehumidier to the retailer

where it was purchased.

If the appliance seems to be working correctly with the

“WORKING” and “POWER” leds on, but no water or

very few is produced, check that the relative humidity in

the room is not lower than 40-45%, otherwise take the

dehumidier to the retailer where it was purchased.

CONNECTION TO A

DISCHARGE PIPE

This dehumidier can be connected directly to a xed

discharge pipe, in this case the tank [if present] is removed

to enable the connection of the pipe to the threaded male

coupling (Fig. 7). For the connection use a pipe with a ¾”

female coupling.

PERIODIC MAINTENANCE

The only maintenance required is cleaning the lter, the

frequency depending on how dusty the room is and how

many hours the appliance actually works each day.

In normal use it is sufcient to clean the lter once a

month, but if the room is very dusty it should be cleaned

more frequently.

The lter is cleaned by washing it under a jet of water in

the sink, owing in the opposite direction to the air ow:

the perforated front panel must face downwards so that

the water pushes the lter against the panel.

After a few years, the hot heat exchanger (condenser)

could need cleaning using compressed air and only

a qualied technician must do this task. This cleaning

improves the appliance efciency and guarantees its long

life.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

master DH 44 INOX Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info