Bedienungsanleitung Mastercraft X14v (Seite 228 von 285) (Englisch)

614259

228

Zoom out

Zoom in

Vorherige Seite

1/285

Nächste Seite

cle’s rear tires. Exceptional care should

be taken to travel as slowly as practical

when traveling on gravel or other loose

surfaces.

• TO ENSURE PROPER OPERA-

TION OF THE TRAILER JACK,

wipe it down and lubricate it on a regular

basis.

• IF THE TRAILER IS BACKED

INTO SALT WATER, you must com-

pletely and thoroughly wash the trailer

in fresh water to retard rusting. Salt wa-

ter is very corrosive, even on galvanized

trailers, and can corrode the braking

system as well. Exposure to salt water

can also cause brake pads to stick and

malfunction.

• THE TRAILER WILL LOOK BET-

TER AND LAST LONGER if it is

rinsed off with fresh water several times

a year. If the boat is run in brackish or

salt water, the trailer should be rinsed

thoroughly after every trip because of

residual effects of the brackish or salt

water. An annual washing with a mild

detergent and waxing with an auto wax

will also help to keep the trailer bright

and clean.

• CHECK THE BRAKING SYSTEM

at the beginning of the boating season

and again at the conclusion, along with

the wheel bearings. If there is anything

that appears to be worn or leaking, take

the trailer to an authorized MasterCraft

dealer for a check and possible repair.

• TOW VEHICLES MUST ALWAYS AP-

PROACH THE TRAILER SLOWLY

prior to being hitched to the trailer. This

allows the operator to retain greater

control. Hard impact with the trailer or

improper alignment on the trailer can re-

sult in damage to the tow vehicle, boat

and/or the trailer, and this is not covered

under warranty. Also, if the trailer is

equipped with the Boat Buddy System,

a hard hit against it could cause damage,

which is also not covered by warranty.

• THE TOW VEHICLE MUST HAVE

A SEVEN-WIRE CONNECTOR in

order for disc brakes and the trailer lights

to function properly. It is important to

properly connect

the seven-wire

connector on the

trailer to the seven-

wire connector on

the tow vehicle.

• The correct method for determining the

load limit is to:

• LOCATE THE STATEMENT,

“The weight of cargo should never

exceed ____ kg or ___ lbs.,” on the

trailer tongue. (This gure equals the

available amount of boat and content

weight capacity.)

• DETERMINE THE COMBINED

WEIGHT of the boat and contents

of the boat being loaded on the vehi-

cle. The boat’s weight is listed in the

Guide to Individual Models section

of this Owner’s Manual. (The total

weight of the boat and contents may

not safely exceed the available cargo

and luggage load capacity listed on

the trailer tongue.)

• WALK AROUND: The majority of po-

tential roadside issues are eliminated by

a walk-around visual inspection. This

should be done after hitching up and

MasterCraft Trailers • 2014 MasterCraft Owners Manual Page 7-3

M A S T E R C R A F T T R A I L E R S

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mastercraft X14v Seite 228

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info