Bedienungsanleitung Mastercraft X30 (Seite 208 von 285) (Englisch)

614263

208

Zoom out

Zoom in

Vorherige Seite

1/285

Nächste Seite

Care and Maintenance • 2014 MasterCraft Owners Manual Page 6-15

C A R E A N D M A I N T E N A N C E

Before Each Use

Before the engine has been started:

• Review the engine manual before each

outing to determine the drive train re-

quirements that need to be followed

prior to each use.

• ReviewtheSafety Checks and Services

section of this Owner’s Manual. There

are important functions that must be

followedbefore,duringandafterevery

outing, without fail!

• Inspect the raw water intake water

strainerforblockage. If there is block-

age, also check the transmission cooler

(where equipped).

• Check and clean as necessary the sea-

cock strainer.

• Check the cooling system level (fresh

watercooling-equippedboatsonly).See

the engine owner’s manual for details.

• Inspectthebatteryconnectionsandhold-

downs.

• Inspectthedrivetrainforlooseormiss-

ing hardware.

• Inspect the throttle and shift cables for

kinks, wear and interference with other

components.

• Inspectthepropellershaftlogforexces-

sivewaterentry.

• Inspectthefuelsystemlinesandconnec-

tions for leaks.

• Check for water leaks or excessive ex-

haust odor.

As you start the engine:

• Checkthatthevoltagereadingregisters

afullychargedbattery.

After Each Use

• Refer to the Cleaning the Boat and

Corrosion Prevention sections of this

Owner’s Manual for guidance on a thor-

oughapproachtomaintenance.Alsopay

attention to the information provided

regarding the maintenance of teak plat-

forms and accessories because the wood

requires periodic maintenance as well.

• Boatsequippedwithanoptionalushing

systemforuseinsaltwaterorbrackish

water should operate the ushing sys-

tem.

Quarterly (Every Fifty [50] Hours)

Before the engine has been started or af-

ter it has cooled:

• Checkthesafetyequipment.

Annually – (Every One Hundred

[100] Hours)

Note: MasterCraft recommends that

the following be performed by autho-

rized MasterCraft technicians at an au-

thorized MasterCraft dealer.

Before the engine has been started or af-

ter it has cooled:

• Replacethefuellter(tobeperformedbyan

authorizedMasterCrafttechnicianonly).

• Checkthepropellershaftcoupleralign-

ment.

• Lubricatethesteeringsystem.

• Lubricatethethrottleandshiftcables.

• Checktheenginemounts.

• Inspect the complete fuel system for

leakage.

• Checkthereextinguisherandsuppres-

sion units on-board.

Details follow in the next few sections.

MasterCraft recommends that many

of these functions be performed by au-

thorized MasterCraft technicians at an

authorized MasterCraft dealer!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mastercraft X30 Seite 208

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info