Bedienungsanleitung Mastercraft X46 (Seite 210 von 285) (Englisch)

614265

210

Zoom out

Zoom in

Vorherige Seite

1/285

Nächste Seite

Care and Maintenance • 2014 MasterCraft Owners Manual Page 6-17

C A R E A N D M A I N T E N A N C E

Step 1: Ensure the engine is OFF and the

enginesafetystartingswitchdis-

connected. Be certain that the

throttle/shift control lever is in

neutral. Locate the battery. Bat-

teriesareplacedinavarietyoflo-

cations, depending on the model.

Check under the observer seat or

behind the rear seat.

Step 2:  Check that the battery post con-

nections are clean and tight. If

not:

• Loosen and remove the negative ter-

minal connection rst. Be careful not

to touch the positive terminal with the

wrench.

• Loosenandremovethepositiveterminal

connection.

• Removethebatteryhold-downsandre-

movethebatteryfromtheboat.

•  Clean corrosion from the battery posts

withabatteryterminalcleaner.

•Cleanthebatterywithawater-and-bak-

ing-soda solution. Use care to avoid al-

lowingthesolutiontoenterthebattery

vents.Rinsethebatterywithfreshwater.

Battery electrolyte fluid is dangerous. It

contains sulfuric acid, which is poison-

ous, corrosive and caustic. If electrolyte

fluid is spilled or placed on any part of the

human body, immediately flush the area

with large amounts of clean water and im-

mediately seek medical attention.

• Useabatteryterminalcleaningbrushto

remove corrosion from the inside of the

battery terminals. Clean the terminals

with a water-and-baking-soda solution

and rinse with fresh water.

• Check the battery box that normally

holdsthebatteryinplacetodetermine

whether there is evidence of battery

uidinsideit.Batteryuidsarecorro-

sive and can cause permanent damage

to the battery box. If uid is evident,

wash out the box with the water-and-

baking-soda solution that is used in

cleaning the terminals. Rinse with

freshwateranddrywithacloth.

• Reconnectthepositiveterminalrst,then

the negative. Tighten the terminals. Coat

bothterminalscompletelywithathincov-

eringofmarinedielectricgrease.Besure

that the rubber boot covers the positive

terminalcompletely.

Note: The boat’s engine is designed to

work with the standard electronics in-

stalled in the boat. Adding other electrical

components or accessories can change the

way the fuel injection controls the engine

or the overall electrical system functions.

Before adding electrical equipment, con-

sult an authorized MasterCraft dealer’s

service department. Otherwise, the engine

may not perform properly.

Add-on equipment may adversely aect

the alternator output or overload the elec-

trical system. Such damage may not be

covered by the warranty.

Ifareplacementbatteryisrequired,be

certain to select a marine battery with at

leastseven-hundred-fty(750)cold-crank-

ing-amps at zero degrees (0

) Fahrenheit.

Before disconnecting the battery, make

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mastercraft X46 Seite 210

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info