Installation of suction stand on horizontal surface
■
Place the suction foot (1) onto a smooth, clean and even surface,
e. g. your car roof .
■
Moisten suction feet to improve suction force
■
Tighten the three screw plugs (2) in a clockwise direction. This generates
a vacuum at the rubber seats, which fixes the suction foot onto the surface.
■
Insert the supporting arm with attached dish and LNB
(see LNB installation section 1) into the mounting hole of the suction foot.
■
Tighten the wing nut on the suction foot (3).
IMPORTANT - Maxview do not recommend verticle
installation with the use of the suction stand
Installation in a case
■
Open the lid of the case and tighten the wing nut to secure it
■
Ensure antenna is secured to the case
■
Insert the support arm (1) with LNB into the opening of the antenna (2)
Installation of LNB and LNB arm
■
Loosen the screws on the LNB bracket (3).
■
Insert LNB (2) in the LNB bracket (1) as shown
■
Tighten the screws of the LNB bracket slightly.
■
Insert the LNB bracket into the supporting arm (4).
■
Tighten the screws of the LNB bracket.
■
Insert the supporting arm into the antenna (5)
NB - Adding some weight in the box will help balance
the dish and stop any wind tipping it over
WARNING -
If you have mounted the antenna on a vehicle roof,
you must dismantle it before travelling.
2
3
1
Installation on a mast with G-clamp
■
Attach G-clamp (1) onto a mast
■
Insert the extension rod (2) in the mounting hole of the G-clamp and
tighten wing nut
■
Insert the supporting arm with attached dish and LNB
(see LNB installation section)
■
Tighten the wing nut on the extension rod
IMPORTANT - Not for permanent fixing
WARNING - Always follow manufacturer’s operating and safety
instructions before using power tools and/or equipment
WARNING - Make sure all the dish parts and G-clamp
are tightly and properly secure
Installation on a wall with the wall mount
■
Place the wall bracket (1) at a position, where it should be installed
■
Mark the position of four fixing holes, drill the four holes and insert wall plugs
■
Position the wall bracket and tighten it with four screws
■
Insert the extension rod in the wall bracket
■
Insert both coach bolts through the wall bracket
■
Fasten nuts on the coach bolts and tighten until the extension rod is fixed into
the wall bracket
■
Insert antenna assembly into extension rod and tighten wingnut (3)
4
5
Installation on a balcony with G-clamp
■
Attach G-clamp (1) on balcony
■
Insert the supporting arm with attached dish and LNB
(see LNB installation section 1)
■
Tighten the wing nut on the extension rod
IMPORTANT INFORMATION
-
Please use this product responsibly
- Keep away from children and animals
- Take care not to cause obstruction with the antenna and cable
- Do not position the system where it could fall and cause injury
- This product is supplied with a 2 year warranty.
It does not cover faults caused by incorrect installation or misuse
GENERAL SET UP GUIDE
