701385
17
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
INPUT
6V
0.2V
40Hz
180Hz
R
L
INPUT LEVEL
LOW PASS
0dB 12dB
BASS BOOST
15Hz
55Hz
SUBSONIC
REMOTE
SLAVE
IN
MASTER
OUT
SLAVE
IN
MASTER
OUT
FUNCTIONS AND OPERATIONAL CONTROLS
1
The SLAVE IN/MASTER OUT switch selects the required operation mode of the amplifier.
In the SLAVE-Mode the amplifier works as a SLAVE amp, this means only the audiosignal of the MASTER amp will be amplified.
All controllers on the SLAVE Amp are without function and will be assumed by the MASTER amp.
In the MASTER-Mode (Low Pass mode) you are able to limit the frequencies to above with the LOW PASS controller. All controllers
are active. NOTE: By using only one amplifier, the Mode-Switch must set to the position MASTER OUT.
3
The INPUT LEVEL controller adjusts the input sensitivity of the amplifier to align the audio signal from the head unit.
The input sensitivity is adjustable from 6 to 0.2 Volts.
6
The SUB SONIC controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid
a mechanical and electical overloading on the subwoofer. The cut-off frequency is adjustable from 15 to 55 Hz and depends on
the size of the subwoofer.
Connect the REMOTE port with the bass remote controller (only in the MASTER mode). The bass remote controller adjust the
bass level e.g. out of the driver’s seat. Please use only the enclosed bass remote controller and cable.
2
4
5
The BASS BOOST controller adjusts the bass enhancement between 0db and +12dB.
7
The LOW PASS controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is
continuously adjustable from 40 Hz to 180 Hz.
8
The MASTER OUT / SLAVE IN RCA jacks are suitable to connect an additional amplifier in MASTER/SLAVE mode.
Attend therefor the chapter Interconnection Example: MASTER/SLAVE on page 19.
6 7 81 43 52
The LINE INPUT RCA jacks must be connected with the RCA output jacks of the headunit. Both of them must be used. If your
headunit only provides one RCA jack, use a y-connector.
F U N C T I O N S A N D C O N T R O L S
NSC750
17
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MB Quart NSC750 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info