Bedienungsanleitung McCulloch Li 58GB (Seite 8 von 16) (Englisch)

684224

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

• Examine the trigger for correct operation.

•

Examine the power button for correct operation.

To install the battery pack

• Align the ribs of the battery pack with the slots in the

battery compartment. Push the battery pack into the

battery compartment until you hear a click.

•

To remove the battery pack, push and hold the

battery release button and pull out the battery pack.

To start the motor

1. Install the battery pack. See

To install the battery

pack on page 8

2. Push the power button until the light is on.

3. Squeeze the trigger to operate.

• Squeeze the trigger lightly for lower speed.

• Squeeze the trigger more for higher speed.

4. Use the product.

To stop the motor

1. Release the trigger.

2. Push the power button until the light is off.

To change the power mode

The power mode of the product can be changed while

the product is in operation. There are 2 power modes:

1. Standard mode - Saves energy and maximizes run

time. Standard mode is applicable for most tasks.

Note The product is set to Standard mode when

started.

2. Boost mode - The product operates at high speed in

Boost mode. Boost mode runs at maximum power

for tasks that are not easy. To start Boost mode,

push the Boost mode button until the light is on. To

stop Boost mode, push the Boost mode button until

the light is off.

Note If the trigger is released during operation, the

product starts in the last mode. If the product

automatically stops, or if the operator pushes the power

button, the last used mode is erased from memory. The

product is set to Standard mode again when started.

To start the digital cruise control

The digital cruise control lets you set and hold a blower

speed without the trigger.

1. Hold the trigger at the necessary position and

engage the digital cruise control.

Release the trigger after the digital cruise control is

engaged.

Note While the digital cruise control is

engaged, the trigger can be pulled again

to increase speed. After releasing the

trigger, the digital cruise control reverts

to its last position.

3. Disengage the digital cruise control to continue usual

operation of the product.

Power meter

The power meter shows how much power the product

uses during operation.

•

LED lights 4 and 5 show the best performance and

best battery efficiency.

• LED light 6 on the right side shows maximum power

and the minimum battery efficiency.

Battery state of charge LED

The status of the battery pack is shown until you pull the

trigger. When you release the trigger, the status of the

battery pack is shown again.

The number of LEDs that are on show the current

charge level of the battery pack.

LED lights Battery status

All Green LEDs

come on

Fully Charged (100% - 76%)

LED 1, 2 and 3

come on

The battery pack is 75% - 51%

charged.

LED 1 and 2

come on

The battery pack is 50% - 26%

charged.

LED 1 comes on The battery pack is 25% - 6%

charged.

LED 1 flashes The battery pack is 5% - 0% charg-

ed.

Note If the motor stops and the power LED stays on,

push the button on the battery pack. For possible

solutions, see

TROUBLESHOOTING on page 9

8 451 - 002 - 20.11.2017

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

McCulloch Li 58GB Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von McCulloch Li 58GB

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info