Bedienungsanleitung McCulloch M3616 (Seite 15 von 17) (Deutsch, Englisch, Französisch, Portugiesisch, Spanisch)

478395

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

TROUBLE CAUSE REMEDY

Engine will not

start or will run

only a few

seconds after

starting.

1. Ignition switch off.

2. Engine flooded.

3. Fuel t ank empty.

4. Spark plug not f iring.

5. Fuel not reaching

carburetor.

1. Move ignition switch to ON.

2. See “Difficult Starting” in

Operation S ection.

3. Fill tank with correct fuel mixture.

4. Install new spark plug.

5. Check for dirty fuel filter; replace.

Check for kinked or split fuel line;

repair or replace.

Engine will

not idle

properly.

1. Idle speed requires

adjustment.

2. Carburetor requires

adjustment.

1. See “Carburetor Adjustment” in the

Service and Adjustments Section.

2. Contact an author ized service dealer.

1. Air filter dirty.

2. Spark plug fouled.

3. Chain brake engaged.

4. Carburetor requires

adjustment.

Engine will not

accelerate,

lacks power,

or dies under

a load.

1. Clean or replace air filter.

2. Clean or replace plug and regap.

3. Disengage chain brake.

4. Contact an authorized service dealer.

Engine

smokes

excessively.

1. Too much oil mixed w ith

gasoline.

1. Empty fuel tank and refill with

correct fuel mixture.

WARNING: Always stop unit and disconnect spark plug before performing all of

the recommended remedies below except remedies that require operation of the unit.

TROUBLESH OOTING TABLE

Chain moves

at idle speed.

1. Idle speed requires

adjustment.

2. Clutch requires repair.

1. See “Carburetor Adjustment” in the

Service and Adjustments Section.

2. Contact an authorized service dealer.

DECLARA TION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)

We, Husqvarna Outdoor Products Italia, S.p.A., Valmadrera, Italy . Tel:

+39--0341--203211, declare that the chain saw models McCulloch M3816 and M4218

CSI ---AV from serial numbers 2008--040(N or D) 00001 and onwards (theyear is clearly

stated on t he rating plate, followed by the s erial number), comply with the requirements

of the COUNCIL’S DIRECTIVES:

of 22 June 1998 “relating to machinery” 98/37/EC, annex IIA;

of 3 May 1989 “relating to electromagnetic compatibility” 89/336/EEC, and applicable

supplements; and

of 8 May 2000 “relating to the noise emissions in the environment” in accordance with

Annex V of 2000/14/EC. The measured sound power is 108 dB(A), the guaranteed

sound power is 118 dB(A) and the net power is 1,6 kW or 1,7 kW.

The following standards have beenapplied: ISO11681--1:2004, EN/ISO 12100--1:2003,

EN/ISO 12100--2:2003, and CISPR 12:2001.

Notified body, 0404 the Swedish Machinery Testing Institute, Fyrisborgsgatan 3

S--754 50 Upp sala, Sweden, has carried out EC type approval. The certificate(s) is

numbered: 404/02/901.

The supplied Chain Saw conforms with thesamplethatunder went theEC typeapproval.

08--02--09

Michael S. Bounds, Director

Product Safety and Standards

Handheld Consumer Products

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

McCulloch M3616 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info