Bedienungsanleitung McCulloch Mac740 (Seite 16 von 17) (Deutsch, Englisch, Französisch, Spanisch)

478386

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

TROUBLE CAUSE REMEDY

Engine will not

start or will run

only a f ew

seconds after

starting.

1. Ignition switch off.

2. Engine flooded.

3. Fuel tank em pty.

4. Spark plug not firing.

5. Fuel not reaching

carburetor.

1. Move ignition switch to ON.

2. See “Difficult Starting” in

Operation Section.

3. Fill tank with correct fuel mixture.

4. Install new spark plug.

5. Check for dirty fuel filter; replace.

Check for kinked or split fuel line;

repair or replace.

Engine will

not idle

properly.

1. Idle speed requires

adjustment.

2. Carburetor requires

adjustment.

1. See “Carburetor Adjustment” in the

Service and Adjustments Section.

2. Contact an authorized service dealer.

1. Air filter dirty.

2. Spark plug fouled.

3. Chain brake engaged.

4. Carburetor requires

adjustment.

Engine will not

accelerate,

lacks power,

or dies under

a load.

1. Clean or replace air filter.

2. Clean or replace plug and regap.

3. Disengage chain brake.

4. Contact an authorized service dealer.

Engine

smokes

excessively.

1. Too much oil mixed with

gasoline.

1. Empty fuel tank and refill with

correct fuel mixture.

WARNING: Always stop unit and disconnect spark plug before performing all of

the recommended remedies below except remedies that require operation of the unit.

TROUBLESHOOTING TABLE

Chain moves

at idle speed.

1. Idle speed requires

adjustment.

2. Clutch requires repair.

1. See “Carburetor Adjustment” in the

Service and Adjustments Section.

2. Contact an authorized service dealer.

DECLARATION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)

We, Husqvarna AB, SE--561 82 Huskvarna, Sweden, Tel: +46--36--146000, as authorised

representative in the Community, declare that the chain saw models McCulloch Mac 738,

Mac 740, and Mac 742 SAS-AV from serial numbers 2009--031(N or D)00001 and onwards

(the year is clearly stated on the rating plate, followed by the serial number), comply with the

requirements of the COUNCIL’S DIRECTIVES:

of 22 June 199 8 “relating to machinery” 98/37/EC, annex IIA;

of 15 December 2004 “relating to electromagnetic compatibility” 2004/108/EC, and applicable

supplements; and

of 8 May 2000 “relating to the noise emissions in the environment” in accordance with Annex

Vof2000/14/EC. The measured sound power is 108,7 dB(A), the guaranteed sound power is

113 dB(A) and the net power is 1,5 kW or 1,6 kW.

The following standards have been applied: ISO 11681--1:2004, EN/ISO 12100--1:2003,

EN/ISO 12100--2:2003, and CISPR 12:2001.

Notified body, 0404 the Swedish Machinery Testing Institute, Fyrisborgsgatan 3 S--75450

Uppsala, Sweden, has carried out EC type approval. The certificate(s) is numbered:

404/05/1079.

The supplied Chain Saw conforms with the sample that un derwent the EC type approval.

09--1--31

Ronnie E. Goldman, Director of En gineering

Handheld Consumer Products

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

McCulloch Mac740 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info