5.2.4 Charging station
Clean the charging station regularly from grass,
leaves, twigs and other objects that may impede
docking.
WARNING: Use the plug to disconnect
the charging station before any
maintenance, or cleaning of charging
station or power supply.
5.3 Replace the blades
WARNING: Use blades and screws of
the right type. McCulloch
can only
guarantee safety when using original
blades. Only replacing the blades and
reusing the screw can result in a screw
wearing during mowing. The blades
can then be propelled from under the
body and cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage. All 3 blades
and screws must be replaced at the same time to
obtain a balanced cutting system. Use
McCulloch
original blades embossed with the crowned H-
mark logotype, refer to
Guarantee terms on page
49
.
5.3.1 To replace the blades
1. Press the STOP button.
2. Open the hatch.
3. Press the ON/OFF button for 3 seconds to
turn off the product.
4. Check that the indicator lamp on the keypad
is not lit.
5.
Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body and the hatch.
6. Remove the 3 screws. Use a straight slot or
cross-tip screwdriver.
7. Remove each blade and screw.
8.
Fasten new blades and screws.
9. Check that the blades can pivot freely.
5.4 Software update
If service is done by McCulloch customer service
then available software updates are downloaded
to the product by the service technician.
However, owners of McCulloch products can
update the software if this is initiated by
McCulloch. Registered users are in that case
notified.
985 - 004 - 22.01.2019 Maintenance - 31
