812475
18
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
A
B B
A
C
MIN.1,5 m MIN.1,5 m
MIN.1,5 m
MIN.0,3 m
16
2-INSTALLATION
EXTERNAL AIR INLET
It is mandatory to provide an adequate external air inlet that supplies the combustion air required for the product to work properly. The
ow of air between the outside and the installation room may be direct, through an inlet in an external wall of the room (preferable
solution see Figure 9 a), or indirect, via air intake from adjoining rooms and connecting permanently with the installation room (see Figure
9 b). Adjoining areas may not include sleeping areas, bathrooms, garages or in general areas with a re hazard. During installation it is
required to check the minimum clearances required to draw air from outside. Take into account the presence of doors and windows that
could interfere with the proper ow of air to the stove (see diagram below).
The air inlet must have a minimum net total area of 80 cm2: the surface must be increased accordingly if there are other active generators
(for example: electric fan for stale air extraction, range cooker hood, other stoves, etc.), which could cause a depression in the room. Make
sure that, with all appliances on, the pressure drop between the room and the outside does not exceed the value of 4 Pa (also for Oyster
appliances if the combustion air has not been suitably ducted outside). If required, increase the intake section of the air inlet, which must
be made at oor level and always protected with a bird-proof outer protection grid and in such a way that it cannot be obstructed by any
object.
It is possible to connect the air required for combustion
directly to the outside air inlet, by using a pipe of at
least Ø50mm, with maximum length of 3 linear
metres. Each pipe bend must be considered equivalent
to a linear metre. To attach the pipe see the rear of the
stove.
For stoves installed in studio ats, bedrooms and
bathrooms (where allowed), it is mandatory to
connect the combustion air outside. Specically for
sealed stoves the connection must be sealed in order
not to compromise the overall sealing of the system.
FIGURE 9 A - DIRECTLY FROM OUTSIDE
FIGURE 10
FIGURE 9 B - INDIRECTLY FROM THE ADJACENT ROOM
A=AIR INLET
B=ROOM TO BE VENTILATED
C=INCREASE OF THE GAP UNDER THE DOOR
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MCZ AKI HYDROMATIC 16 M1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von MCZ AKI HYDROMATIC 16 M1

MCZ AKI HYDROMATIC 16 M1 Bedienungsanleitung - Deutsch - 64 seiten

MCZ AKI HYDROMATIC 16 M1 Installationsanweisung - Deutsch - 52 seiten

MCZ AKI HYDROMATIC 16 M1 Bedienungsanleitung - Englisch - 64 seiten

MCZ AKI HYDROMATIC 16 M1 Installationsanweisung - Holländisch - 48 seiten

MCZ AKI HYDROMATIC 16 M1 Bedienungsanleitung - Holländisch - 64 seiten

MCZ AKI HYDROMATIC 16 M1 Installationsanweisung - Französisch - 48 seiten

MCZ AKI HYDROMATIC 16 M1 Bedienungsanleitung - Französisch - 64 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info