Bedienungsanleitung MCZ ALEA AIR 7 S1 (Seite 17 von 36) (Englisch)

812522

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

15-ALARMS

NORMAL SHUTDOWN (on the panel: OFF with ashing ame)

When the shutdown key is pressed, or when there is an alarm signal, the stove enters the thermal extinguishing stage which involves

automatic execution of the following stages:

• Pellet loading stop

• The room fan maintains the set speed until reaching the shutdown temperature

• The smoke extractor fan is activated at maximum speed and remains on for a xed period of 10 minutes, at the end of which if the

smoke T has dropped below the shutdown threshold, the fan stops, otherwise it will continue to operate at minimum speed until the

temperature drops below the threshold and then turn o.

• If the stove has been shut down regularly but, due to thermal inertia, the smoke temperature exceeds the threshold again, the

shutdown stage will be repeated at minimum speed until the temperature drops.

BLACKOUT WITH STOVE ON

In the event of a blackout, the stove acts as follows:

• Blackout less than 10”: resumes operation;

• After a power outage of more than 10’’ which occurred when the stove was on, or during ignition, when the stove is powered again

it returns to its previous operating condition as follows:

1. Cools the boiler by activating the smoke extractor at minimum speed for 10’ then proceeds to the next step;

2. Restores the stove to the operating condition prior to the blackout.

During stage 1, the panel shows ON BLACK OUT.

During stage 2, the panel shows Ignition.

If during stage 1 the stove receives manual user commands from the control panel, it stops the blackout reset sequence and begins the

start-up or shutdown as requested by the user.

BLACKOUT OF MORE THAN 10’’ DURING STOVE SHUTDOWN

If the stove experiences a loss of power LONGER THAN 10” while it is shutting down, when power is restored to the stove, it will

automatically turn on in shutdown mode, even if the smoke temperature has fallen below 45°C in the meantime. This last stage can be

skipped by pressing key 1 (esc) (skips to start-up) and pressing it again (recognises that the stove is o).

BLACKOUT OF MORE THAN 10’’ WITH THE STOVE OFF FOR ECOSTOP

Once power has been restored, a 5-minute timer is set as though the stove were in shutdown mode. Should there be a request for heat in

these 5 minutes, the stove will not start.

SAFETY DEVICES ALARM A05

The safety devices alarm includes operation of the smoke pressure switch, of the fuel loading hatch and of the open stove door.

The alarm will be triggered after 30 seconds, after which the stove will stop working (e.g. after 30 seconds with the pellet loading

hatch open, alarm A05 will be triggered).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

MCZ ALEA AIR 7 S1 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von MCZ ALEA AIR 7 S1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info