38
7-MAINTENANCE AND CLEANING
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets
(ceramic bre cord).
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
PULLING THE PRODUCT OUT
Part of the product must be extracted from its seat for maintenance to be performed on certain devices and to clean certain parts. The
mobile part is tted on sliding guides, which facilitate the handling process. The compensation frame must be removed by following the
instructions in this manual before pulling the product out in order to prevent any damage during maintenance. The two lower front screws
must be removed from the product in order to pull it out.
Once the screws are removed, simply exert slight force towards you to pull the mobile part like a drawer. The guides have an end-of-travel
that block the mobile part when extracted completely.
ATTENTION: THE PRODUCT MUST ONLY BE PULLED OUT WHEN COLD AND THE POWER SUPPLY MUST BE DISCONNECTED
IN ADVANCE.
When the mobile part is set back in place, make sure the two screws removed previously are tightened well. The
product may not work if the above is not done, due to no power supply or leaking soot.
CLEANING THE HEAT EXCHANGER
The compartment through which the exhaust smoke passes must be cleaned at the end of the winter season.
This cleaning process is mandatory in order to facilitate the general removal of all combustion residue, before it becomes very dicult to
remove it due to the humidity compacting it over time.
If necessary, clean it more often.
It is good practice to guarantee eective ventilation in the room while cleaning the product.
When the appliance is cold, open the door and remove the ash pan “D” as well as the brazier “C”. Then loosen the three screws “B” just
above the hearth opening and remove the bracket “A” that blocks the internal refractory parts made of Alutec.
Gently remove the lateral sides “E” and then the rear panel “F” with bracket “H” that keeps it blocked in place.
