Bedienungsanleitung MCZ CLUB Hydromatic 24 ACS M2 (Seite 8 von 68) (Englisch)

812518

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

1-WARNINGS AND WARRANTY CONDITIONS

INFORMATION:

• Please contact the retailer or qualied personnel for any information, problem or malfunction.

• Only use the fuel specied by the manufacturer.

• When the product is switched on for the rst time, it is normal for it to emit smoke due to the paint heating up for the rst time.

Therefore make sure the room it is installed in is well-ventilated.

• Periodically check and empty the inspectionable parts of the smoke duct (e.g. Tee tting caps)

• Have the smoke outlet system periodically checked and cleaned

• The product is not a cooking appliance.

• Always keep the cover of the fuel hopper closed.

• Store this installation and user manual with care as it must accompany the product for the duration of its useful life. If the product is

sold or transferred to another user, always ensure the manual is also handed over.

INTENDED USE

The product only works with wood pellets and must be installed inside a room.

PRODUCT PERFORMANCE CHECKS.

All our products undergo ITT TESTS carried out by a notied third party laboratory (system 3) and in accordance with Regulation (EU)

number 305/2011 “Construction products”, according to standard EN 14785:2006 for household appliances and “Machinery Directive” EN

303-5 for boilers.

In the case of tests for any market surveillance or inspections by third parties, please consider the following warnings:

• To reach the declared performance levels, the product must perform an operating cycle of at least 15-20 hours beforehand.

• Set the average draught of the combustion fumes as specied in the “technical product features” table

• The type of pellets used must comply with the current EN ISO 17225-2 class A1 regulation. Fir pellets are usually used for certication.

• The amount of thermal energy can vary according to the length and caloric value of the fuel. This may require some adjustments

(accessed from the user menu) to comply with the hourly consumption specied in the “technical product features” table. Using class

A1 pellets guarantees a caloric value that is likely to be close to that used in the product certication; the size of the pellet grains can

signicantly aect hourly fuel loading and consequently performance; it is therefore suggested to use pellets with a 6 mm diameter

and an average length of around 24 mm (avoid pellets that are too long or excessively crushed).

• With wood-burning appliances, the fuel must comply with the current EN ISO 17225-5 class A1 regulation. Check the correct moisture

of the fuel, as it must be within the range of 12 - 20% (it is best if the moisture is close to 12%, as is normally used in certication). As

the fuel moisture increases, dierent combustion air settings are required, which are implemented from the combustion air register,

thereby modifying the mixture of primary and secondary air

• It is important to check the operation of devices that can aect performance (for example air fans or electric safety devices) in case

of damage due to handling.

• Nominal performance has been obtained by setting the maximum ame power and room ventilation in manual mode.

Performance at reduced power was achieved at minimum ame and ventilation power (P1 and V1) in manual mode.

The other conditions correspond to intermediate ventilation and power.

• If a “verication” mode is provided in the menu, set this function during the readings to ensure that no temperature modulation

occurs due to an incorrect setting of the operating parameters.

• Lastly, strictly comply with the sampling points specied in the regulations in terms of emissions as well as temperature

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

MCZ CLUB Hydromatic 24 ACS M2 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von MCZ CLUB Hydromatic 24 ACS M2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info