PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 40
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
4. OPERATION
4.1. PRE-LIGHTING WARNINGS
Do not touch the stove during the first lighting, as it
is during this phase that the paint sets. If you touch
the paint, you may expose the steel surface.
If necessary, touch up the paint with the aerosol spray in the original
colour (see the section "Accessories for pellet stoves").
It is good practice to provide plenty of ventilation in
the room during the initial lighting, as the stove will
give off a small amount of smoke and smell of paint.
Do not stay near the stove, and as previously mentioned, ventilate the
room. The smoke and the smell of paint will vanish after about one
hour of operation. There are no health risks involved.
The stove will be subject to expansion and contraction during the
stages of lighting and cooling down, and may therefore make slight
creaking noises.
This phenomenon is absolutely normal, the structure being made of
sheet steel, and must not be considered a fault.
It is extremely important to be sure not to take the stove to full heat
straight away, but to bring it gradually up to temperature.
Do not demand full heating
performance straight away!
Try to get familiar with the commands given from the control panel.
