PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 30
Operation Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
Mode:MANU Menu
Fire:1 Fan:2
Mode:MANU Menu
Fire:1 Fan:2
21.0°C 21.04
OFF
4.7. Power supply (panel display: ON)
Once the lighting phase has ended the stove goes to flame level 3 and
then increases (or decreases, according to that required by the setting)
power at one value per minute.
There are three methods of setting the flame during operation at full
power:
Manual
Automatic
Eco stop
Then grate cleaning is added, the stove runs this automatically
according to the modes described below.
4.8. OPERATING MODE
KAIKA-FACE stoves have two operating modes: MANUAL and
AUTOMATIC.
MANUAL mode allows adjusting the flame from power 1 to power 5,
ignoring any ambient temperature measurements.
This mode is indicated by the word MANU on the display of the
control.
AUTOMATIC mode, on the other hand, lets you set the desired
temperature in the room of installation. The stove will control its power
autonomously in order to reach and maintain the established
temperature in the room. This mode is indicated by the word AUTO on
the control panel.
With this mode you can also use an advanced function called AUTO-
ECO which is described later (
paragraph 5.4.2.
)
At each lighting, the stove automatically sets to the
operating mode that it was in the last time it shut
down.
4.8.1. Manual mode
Flame power is adjustable from a minimum of 1 to maximum of 5.
The levels of power correspond to a different fuel consumption value:
by setting 5 the room will be heated in less time, setting 1 the room
temperature will be maintained for a longer period of time.
The peculiarity of this setting is that the flame stays at the set value
regardless of room temperature.
The flame power setting is only effective after
ignition and therefore in full working order.
Manual mode
