632414
48
Zoom out
Zoom in
Vorherige Seite
1/57
Nächste Seite
PELLET STOVES Chapter 6
INSTALLATION AND USE MANUAL
page 48
Safety devices Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
The table below describes the possible alarms signalled by the stove,
associated to the respective code that appears on the emergency
panel, and useful suggestions to solve the problem.
MESSAGE ON
DISPLAY
TYPE OF PROBLEM SOLUTION
A01
Fire fails to ignite
Check the level of pellets in the hopper.
Check that the grate is properly inserted in its housing
and does not have any obvious unburnt incrustations;
A02
Fire extinguishes abnormally
Check the level of pellets in the hopper.
Check that the grate is properly inserted in its housing
and does not have any obvious unburnt incrustations;
A03
Pellet tank temperature exceeds foreseen
safety limit.
Structure has overheated due to reduced heat
dissipation
Wait for the end of the cooling phase, cancel the alarm
and reli
g
ht the stove placin
g
the fuel load to minimum
(SETTINGS MENU - Pellet recipe) and increasin
g
the room
fan speed. (V1-V5). If the alarm persists, contact technical
support.
A08
Anomalous operation of smoke fan.
Check that the
g
rate does not have visible unburn
t
incrustations. If the alarm persists, contact technical
support.
A09
Smoke temperature too high or smoke probe
faulty
Wait for the end of the coolin
g
phase, cancel the alarm
and relight the stove placing the fuel load to minimum
(section 5.4.4.) and increasin
g
the room fan speed (section
5.4.5). If the alarm persists, contact technical support.
6.2. Exiting alarm condition
To reset the alarm hold the On/Off key down for a few moments: the
stove runs a check to assess whether the cause of the alarm persists or
not. In the first case the alarm will be displayed once again, in the
second case it will go to Off.
Only after the cause of the blockage has been permanently eliminated
can another attempt to relight the stove be made.
6.3. Normal shutdown (panel display: shutdown)
If the shutdown key is pressed or there is an alarm signal, the stove
enters the thermal shutdown phase foreseeing automatic execution of
the following phases:
Pellet loading stops
The room fan maintains set speed until smoke T reaches
100°C, then it automatically sets to minimum speed until
shutdown temperature is reached
The smoke fan sets on maximum and stays there for a fixed
time of 10 minutes, at the end of which if smoke T has dropped
below 45°C (parameters can be displayed in the INFO menu) it
shuts down definitively, otherwise it sets to minimum speed
until such threshold is reached and then shuts down.
Downloaded from www.Manualslib.com manuals search engine
48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MCZ KAIKA Air wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von MCZ KAIKA Air

MCZ KAIKA Air Bedienungsanleitung und Installationsanweisung - Holländisch - 58 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info