REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE SAFE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE
PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE EVERY RESTART
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
Ash tray cleaning
Remove and empty the “U” ash tray. Wipe away any residual ash before reinserting the tray. Your experience and the quality of the pellets
will determine the ash tray cleaning frequency. However, it is recommended not to exceed 2 or 3 days.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass cleaning product on the painted parts and on the door
gaskets (ceramic bre cord).
CLEANING THE AIR FILTER
A wire mesh air lter is found at the back of the stove, whose purpose is to prevent dirt entering the motor body and the internal sensor.
It is recommended to check that the lter is clean every 15/20 days. If needed remove u or the material that has deposited on it.
Inspection and cleaning are required more frequently if there are pets in the house.
Simply remove the lter to clean. To clean it use a brush or a damp cloth or compressed air. Set it back in place by simply pressing it
(interlocks).
The lter is made of metallic mesh and is soft and exible to the touch therefore, when cleaning, be careful not to
crush or damage it. In the event of breakage it must be replaced.
ATTENTION!
Never let the stove work without the air lter tted. MCZ cannot be held liable for any damage caused to the internal
components if this requirement is not complied with.
