643409
49
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
47
12-MAINTENANCE AND CLEANING
Technical Dept. - All rights reserved - Reproduction is prohibited
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets
(ceramic bre cord).
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
PULLING THE PRODUCT OUT
Part of the product must be extracted from its seat for maintenance to be performed on certain devices and to clean certain parts. The
mobile part is tted on sliding guides, which facilitate the handling process. The compensation frame must be removed by following the
instructions in this manual before pulling the product out in order to prevent any damage during maintenance. The two lower front screws
must be removed from the product in order to pull it out.
Once the screws are removed, simply exert slight force towards you to pull the mobile part like a drawer. The guides have an end-of-travel
that block the mobile part when extracted completely.
ATTENTION: THE PRODUCT MUST ONLY BE PULLED OUT WHEN COLD AND THE POWER SUPPLY MUST BE DISCONNECTED
IN ADVANCE.
When the mobile part is set back in place, make sure the two screws removed previously are tightened well. The
product may not work if the above is not done, due to no power supply or leaking soot.
CLEANING THE HEAT EXCHANGER
The compartment through which the exhaust smoke passes must be cleaned at the end of the winter season.
This cleaning process is mandatory in order to facilitate the general removal of all combustion residue, before it becomes very dicult to
remove it due to the humidity compacting it over time.
If necessary, clean it more often.
It is good practice to guarantee eective ventilation in the room while cleaning the product.
When the appliance is cold, open the door and remove the ash pan as well as the brazier. Then loosen the three screws just above the
hearth opening and remove the bracket that blocks the internal refractory parts made of Alutec.
Gently remove the lateral sides and then the rear panel with the bracket that keeps it blocked in place.
49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MCZ Vivo 80 Pellet COMFORT AIR wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von MCZ Vivo 80 Pellet COMFORT AIR

MCZ Vivo 80 Pellet COMFORT AIR Bedienungsanleitung und Installationsanweisung - Französisch - 56 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info