Bedienungsanleitung Meaco 54Lm (Seite 6 von 12) (Englisch)

661772

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

6 [EN]

2. GENERAL ADVICE

Before putting your dehumidifier into operation for the first time, the instructions manual should be studied carefully.

After receiving the unit, you should check your dehumidifier for any transport damage. In case of damage, you should

inform the sender immediately.

Transport damages should be stated after unpacking the equipment. The respective seller or specialised reseller should

be contacted immediately.

Keep the packaging for the dehumidifier in a safe place in order to be able to despatch the dehumidifier safely if it

requires a service. In order to save space, you can simply cut through the adhesive tape using a knife and fold up the

cardboard box.

3. DEHUMIDIFIER PRINCIPLES

This dehumidifier is designed to reduce humidity from the air in a building or part of a building. The purpose is to prevent

humidity damage, and to dry out wet materials such as carpet, floors, walls, furniture, contents, timber, and structural

materials.

This dehumidifier can prevent the formation of condensation, reduce air humidity and keep constant a desired relative

humidity value. The time necessary for the dehumidifier to dry a room and reach the desired relative humidity depends

on the environmental conditions prevailing within the room. For example the number of air changes with outside, any

sources of moisture and the room temperature can all either speed up or slow down the dehumidification process.

The dehumidifier functions according to the condensation principle with heat recovery. The fan takes the humid air from

the room in and across a filter and then through an evaporator. Here the air is cooled below dew point so that the water

vapour of the air forms a condensate on the coils which flows into the water collecting tank. The cooled and dried air is

heated again by a condenser. By recycling the room air through the dehumidifier over and over again the moisture content

and relative humidity of the air is reduced.

4. INSTALLATION AND TRANSPORTATION

For installation and transportation, the following instructions must be considered:

 The air inlet and the air outlet must not be covered whilst the dehumidifier is in operation.

 Before any moving the dehumidifier it must be switched off by its ON-OFF switch. The mains plug is to be removed

from the socket and the water tank should be emptied.

 For transportation the dehumidifier should be secured on a level base only and must be prevented from rolling

around.

 The dehumidifier must always be transported vertically.

 This dehumidifier must be used exclusively for air dry.

 If the dehumidifier has been in a horizontal position for any time over a few minutes, you must let it stand in the

upright position for at least 30 minutes before operating. This allows the oil to drain back into the compressor.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Meaco 54Lm Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info