9
CONTINOUS DRAINAGE OPTION 2 (via a pump)
A pump can also be used to enable continuous drainage. Please note the pump is not included and
can be purchased separately via www.meaco.com. The hose required needs an internal diameter of
8mm. For continuous drainage via a pump proceed as follows:
- Set the unit to Standby Mode and disconnect the mains plug from the socket.
- Remove the water tank from the dehumidifier and empty any water which may have been
collected.
- Fit an 8mm diameter hose, with the desired length, onto the water outlet of the submersible
pump and make it pass through the panel cut-out hole of the housing, placing the pump in
side the tank afterwards.
- Plug in the pump to the pump socket located beneath the water pan in the centre and insert
the water tank back into the unit.
- Extend the hose to the desired drainage point. NOTE: The maximum water column height our
pump kit handles is 4 metres (elevation always depends on the pump used).
- Plug the unit into the mains and set the desired target humidity level or Continuous Mode.
- Test the pump is working correctly by adding water to the water tank until you are able to see
water is being pumped out of the water tank and draining through the attached hose.
MEMORY FUNCTION / AUTO RE-START
When the dehumidifier is switched off, either by the mains or via a power cut, when turned back on the
dehumidifier will continue to run in the same settings it was previously running on.
If you wish to reset the dehumidifier to its factory default settings switch the dehumidifier off using the
mains button, unplug it from the mains, wait a few minutes, plug it back into the mains and then switch
the unit back on using the mains.