446411
112
Zoom out
Zoom in
Vorherige Seite
1/175
Nächste Seite
EN-25
EN
Sewing in zips
Use the zip sewing foot.
Depending on which side of the zip band you are sewing, the se-
wing foot must always be on the fabric.
For this reason, the sewing foot is attached on either the left-hand
or right-hand side, and not in the middle like all other sewing feet.
Raise the sewing foot and needle to its highest position to switch
the sewing foot.
Place the zip on the fabric and place the workpiece in position
under the foot.
To sew the right-hand side of the zip, attach the zip sewing foot
so that the needle sews on the left-hand side (1).
Sew the right-hand side of the zip, creating the stitches as close
as possible to the teeth. (1)
Sew the zip in with a bridge around 0.5 centimetres below the
teeth.
To sew the left-hand side of the zip, change the foot position on
the sewing foot holder.
Proceed in the same way as for the right-hand side of the zip (2).
Before the foot reaches the slider on the zip band, lift the foot up
and open the zip, keeping the needle in the material. (3)
Sewing in a drawstring
You can also use the zip sewing foot to sew in drawstrings, as illu-
strated.
Fold the fabric over once to create a drawstring tunnel and then
sew along the drawstring, making sure the zip sewing foot is be-
hind the drawstring.
Hems
You can use the roll hem/hemming sewing foot to easily hem fine
to medium materials, e.g. blouses, silk scarves and flounces. Hem-
ming using the roll hemmer stops the edges from fraying and crea-
tes a clean, durable edge.
Raise the sewing foot and needle to its highest position and re-
place the existing foot with the hemming foot.
Fold the start of the hem around 2 mm in with a double fold.
Insert this folded hem into the coil of the roll hemming foot.
Carefully and slowly sew a few stitches, preferably by turning
the hand wheel (10).
If the start of the hem was pulled into the foot, carefully start se-
wing the hem.
Always hold the edge of the fabric somewhat over the left-hand
side of the sewing foot, to stop the fabric slipping out of the coil.
Make sure that the fabric does not slip under the right-hand side
of the sewing foot.
112

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

medion-md11836

Suche zurücksetzen

  • Bei meiner Medion Nähmaschine funktioniert der Mitnehmer nicht, sodaß der Stoff nicht gleichmäßig transportiert wird, was kann ich da tun? Eingereicht am 27-10-2022 10:13

    Antworten Frage melden
  • Der Mitnehmer funktioniert
    No






    Der Mitnehmer funktioniert nicht, woran kann das liegen

    Eingereicht am 15-9-2019 18:17

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Medion MD11836 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Medion MD11836

Medion MD11836 Bedienungsanleitung - Deutsch - 42 seiten

Medion MD11836 Bedienungsanleitung - Holländisch - 44 seiten

Medion MD11836 Bedienungsanleitung - Französisch - 42 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info