Bedienungsanleitung Medisana BS477 - 40437 (Seite 24 von 28) (Deutsch, Englisch, Holländisch, Französisch)

673337

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

ENGLISH

5 Insert/replace batteries

Two button cell batteries (type CR2032) are already inserted in your new scale. The insulating strip

must be pulled out of the battery compartment



on the underside of the unit before the scale can

be operated. Replace the batterie if the battery change symbol "LO" appears in the display



or if

nothing appears in the display after you have stepped on the device. To do this, open the battery

compartment



beneath the device and insert two cell batteries (type CR2032). Please note polarity

(positive pole upwards; facing towards the lid). Close the battery compartment



again.

WARNING

Battery safety information

• Do not disassemble batteries!

• Clean the battery and device contacts if necessary before putting in the batteries!

• Remove discharged batteries from the device immediately!

• Increased risk of leakage, avoid contact with skin, eyes and mucous membranes! If battery acid

comes in contact with any of this parts, rinse the affected area with copious amounts of fresh

water and seek medical attention immediately!

• If a battery has been swallowed seek medical attention immediately!

• Insert the batteries correctly, observing the polarity!

• Keep the battery compartment well sealed!

• Remove the batteries from the device if it is not going to be used for an extended period!

• Keep batteries out of children's reach!

• Do not attempt to recharge these batteries! There is a danger of explosion!

• Do not short circuit! There is a danger of explosion!

• Do not throw into a fire! There is a danger of explosion!

• Keep unused batteries in their packaging away from metal objects in order to prevent short

circuiting!

• Do not throw used batteries into the household refuse; put them in a hazardous waste container

or take them to a battery collection point, at the shop where they were purchased!

6 Change the unit of weight

You may have your weight displayed in kilograms (kg), pounds (lb) or stones (st). Switch the scales on

by touching with the foot and press the



button until the desired units are displayed.

7 Weighing “Step-on”-function

1. Make sure the scales are on a firm, level surface. If you only want to weigh yourself but have moved

the scales just before, you must first initialise the scales. To do this, press your foot on the middle

of the surface of the scales. "0.0 kg" appears in the display. When the scales switch off, they are

ready for the “step-on” function. This procedure is not necessary if you have not moved the scales.

2. Step onto the scales and stand still. The device switches on automatically and the display



briefly

shows "0.0 kg".

3. Your weight is measured, flashes three times and is then finally displayed.

4. Step down from the scales. The scales switch off automatically after 12 seconds.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Medisana BS477 - 40437 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info