Bedienungsanleitung Medisana HKC 60114 (Seite 16 von 76) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

477245

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Additional information for the heat pad for neck and back (Art. 60124 HKN)

This specially-shaped back and neck pad is especially designed for use on these

areas of the body. It is individually adjustable to your body thanks to hook and loop

fasteners in the neck and hip areas. G

3 Miscellaneous

3.1 Troubleshooting

This unit is equipped with the active protection system APS TECH. The unit detec-

ts different causes of errors and emits corresponding alarm sounds if necessary. In

the case of an error, the power LED will light up in red.

3 beeps in 1-second interval and power LED lights up in red:

The connection cable of the control unit is not properly connected to the heat pad or

another electrical defect is present. Please check the cable connection. Is the cable

connected properly, please do not use the heat pad and contact the service center.

3 beeps in 2-second interval for one minute and power LED lights up in red:

The heat pad is broken, folded or fully covered. Please use the heat pad only

according to this instruction manual and pay attention to all points in the safety

information chapter.

Constant beeping and power LED lights up in red:

Important components are damaged or there is a short circuit. Please do not use

the heat pad and contact the service center. G

If there is no function at all after switching on the heat pad (power LED shows

no light and no beeps can be heard), please check if the mains plug is correctly

plugged in the mains outlet. If this is the case, the heat pad is defect. Please do

not use the heat pad and contact the service center. G

Heat pad

3.2 Cleaning and maintenance

•

Before cleaning the pad, unplug it from the mains outlet and let it cool down for

at least ten minutes.

The heat pad can be cleaned with a soft brush when dry.

The heat pad may be carefully washed by hand. Ideally you should place the

heat pad in a bathtub with warm water and a little mild detergent and squeeze

it gently.

Rinse the pad several times to get rid of any remaining detergent.

Never use strong detergents or hard brushes.

To dry, lay the pad flat on a moisture-absorbent towel or mat.

Only use the blanket again once it is completely dry.

The heat pad is equipped with a removable control unit

60114 / 60124 / 60144: “HKC, -M, -N”). Unplug the control unit from the heat

pad by pulling out the connection cable from the plug on the heat pad.

(Art. 60104: “HKS”; Art.

•

Reconnect the control unit to the heat pad in the

correct manner (please see the sketch, the arrow

markings are showing towards each other).

You should untangle the cable from time to time.

Store the unit in a clean and dry place, laid out flat

with nothing covering or resting on top of it.

•

2 Operating / 3 Miscellaneous

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Medisana HKC 60114 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info