Bedienungsanleitung Medisana MCN PRO - 88970 (Seite 30 von 130) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

743099

Zoom out

Zoom in

Vorherige Seite

1/130

Nächste Seite

3 Operating

The use of the shiatsu massage seat cover will improve your wellbeing after a

stressful day. The massage effect is particularly useful for treating tense muscles

and tired tissue. The unit provides pleasant relaxation for overcoming everyday

stress. The massaging can improve your well-being, and is also useful in the

sport and fitness areas.

Start-up

•

The transport lock which is located on the rear of the backrest at the base,

must be removed before the device is first used (see illustration at the front

of the Instruction Manual). Be sure to observe the safety information (see

chapter 1 Safety instruction, sub-heading before using the device and

the according illustration at the front of this Instruction Manual).

• Place the

massage seat cover

on a high chair or armchair and attach it to this

by means of the fasteners

on the back.

Ensure that the seat cover is

supported over its entire area and has a sufficiently high backrest.

•

Insert plug

into the mains socket. Ensure that the power supply is easily

accessible.

•

Take a seat on the shiatsu massage seat cover and familiarise yourself with

the functions.

•

Sit comfortably and upright. Ensure you sit centered and such that the

massage heads

can move to the left and right of your spinal column.

Operating the unit

The MCN PRO shiatsu seat cover has three functions for an effective massage:

fingertip massage (Shiatsu massage), vibration massage and heat. The heat

function can only be used together with the shiatsu massage in the back,

during which the neck massage and the vibration massage in the seat can also

be activated. Do not use the unit for more than 15 minutes at a time. After

approx. 15 minutes, the unit will switch off automatically. Always allow the

unit to cool down fully before you use it again.

Buttons on the control unit

Use the buttons on control pad

to operate the massage seat cover:

Switch on the device by pressing On/Off button

. The LED illuminates. The

device starts with standby mode. If no other button is pressed, the device turns

off after 15 minutes automatically.

Demo button

You may activate demo function with or without pressing On/Off button

before.

Press the Demo button

, the device starts automatically with

introduction of different back setting with different functions.

First massages in neck /shoulder and full back region are presented. The

rotating back massage heads

move from the entire bottom (start position)

to the entire top; the rotating neck massage heads

move outwards.

Simultaneously heat in the back and vibration in the seat are activated, while

intensity of vibration is set on lowest level.

3.1

Usage

3.2

Operation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Medisana MCN PRO - 88970 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info