Bedienungsanleitung Meireles MF7606 (Seite 48 von 84) (Deutsch, Englisch, Portugiesisch, Spanisch)

673504

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

MANUAL DE INSTRUÇÕES · MANUAL DE INSTRUCCIONES

INSTRUCTION MANUAL · GEBRAUCHSANLEITUNG

2.3

INSTALLATION AND ASSEMBLY

To ensure that the oven functions correctly, the dimensions shown in the figures in section 10 must be

respected, specifically:

Fresh air inlet in the furniture's skirting board (figure reference A)

Distance from the top of the oven and the bottom of the board placed above it

(figure reference B). Distance between the oven's door and the door of the

adjacent furniture (figure reference C). Fresh air circulation (figure reference D)

The dimensions of the opening are shown on the figures in section 10 (585x560 mm).

Insert the oven into the opening in the furniture by supporting its base and pushing it

right to the back.

Open the door and fix the oven to the furniture using the four bolts supplied (see figure in section 10).

Furniture material must resist temperatures of up to 90°C.

The oven's electrical connection must be made independently of any other connection.

We recommend the following precautions prior to using the oven:

remove the protective film covering the oven's door glass (if present):

heat the oven to its maximum temperature without food inside for around 45 minutes to eliminate

unpleasant smells and smoke cause by manufacturing residue and the thermal insulation;

carefully clean the inside of the oven with soap and water and rinse well with clean water

IMPORTANT: During use, the front of the oven heats up significantly. Care must be taken when touching

these parts.

2.1

ELECTRICAL CONNECTION

The oven is fitted with an electrical power supply cable and is designed to operate with alternating current at

the voltage indicated on the plate showing the "oven's technical data", found on a label on the product. The

electric cable's earth connector is yellow and green

2.2

CONNECTING THE CABLE TO THE POWER SUPPLY

The oven must be connected to the power supply by a technically qualified person with knowledge of current

installation standards and regulations.

Before turning the oven on, make sure that the electrical connections and protection devices are suitable for

the product's technical characteristics.

To connect the product to the electricity supply, an all-pole circuit breaker must be installed between the oven

and the power supply, with a minimum gap between the contacts of 3mm. This circuit breaker should be

appropriate for the load and correspond to current safety regulations.

The earth cable, identifiable by its green/yellow colours, must not run through the switch.

The manufacturer shall not be liable for any direct or indirect damage caused by incorrect installation or

connection.

Therefore, all electrical installation and connection work must be carried out by specialist personnel and

work must be done in compliance with current local and general regulations.

INSTALLATION INSTRUCTIONS



Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Meireles MF7606 Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info