Additional check
Check that some of the other
functions used on your original remote
control are working correctly.
If the commands function incorrectly
or erratically, you have probably
entered a code for a similar but
different remote control.
In this case, repeat the search
procedure from point 2.
1. Make sure that the TV is ON.
2. Hold down the SHIFT
and ON/OFF keys together
until the light indicator at the
top starts to flash indicating
that the remote control is in
programming mode.
3. Release the keys.
Within 15 seconds,
enter the code 000.
The light indicator flashes more
quickly to indicate that the remote
control is ready for the search.
4. Point the remote control at the TV.
Press and release slowly one of
the most frequently used keys
several times STOPPING when
the appliance responds correctly
to the command.
5. When the TV responds correctly,
press SHIFT to confirm.
Three flashes indicate that
the operation has been
completed correctly.
Identify and make a note of the TV
code which you have searched
for, following the code noting procedure
(see “NOTING THE PROGRAMMED
CODE” section).
NOTE: THE LIGHT INDICATOR
STOPS FLASHING.
The remote control leaves the
programming mode and the light
indicator stops flashing:
• if no keys are pressed for 15 seconds
• if the code search list is completed.
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
C
This operation may take up to about 20 minutes.
0
0
0
Count the number of flashes for
each code number.
For example, for the code 306, the key
flashes three, zero and six times to
give:
= 3
= 0
= 6
4. Note this code on the label
inside the battery cover
for rapid consultation.
NOTING THE PROGRAMMED CODE
To find the code for your remote control:
1. Hold down the SHIFT and ON/OFF
keys together until the light indicator at
the top starts to flash.
2. Release the SHIFT and ON/OFF keys
and then press and release the 1-/--
key.
3. After a few seconds, the light
indicator communicates the
code you are looking for by flashing
the three numbers separately.
1-/--
Always write down the 3-digit code for your remote control on the label inside the
battery cover after running the search and saving the code. This may be useful if you
need to reprogram your remote control in the event of accidental cancellation or when
you change used batteries. If you forget to write down the code or use the remote
control programming procedures A or C ... don’t worry!
