ASSEMBLY
• Attach the pole (1) to the bottle
holder (3). Turn it clockwise until it
clicks into place.
• Attach the xing aid (5) to the pole.
• Attach the accessory tray (4) to the
pole.
USING THE APPLIANCE
1. Pour approx. 120 ml of water into
the base of the appliance (7). Use
cold water from the tap only.
2. Place the bottle holder in the
base. It is important that all parts
– both bottles and teats - are
carefully cleaned with a brush or
similar before using the steriliser,
otherwise the parts cannot be
sterilised.
3. Place the clean bottles into the
bottle holder. The bottles should
be placed upside down. Place
teats and any other accessories in
the accessory tray.
4. Place the lid (2) onto the base and
connect the appliance. An "H" will
be shown on the display (8).
5. Ensure that the steam hole is not
blocked, as steam will need to
escape.
6. Press the on switch (9). A rotating
circle will be shown in the display
and the appliance will start heating
the water.
o When the water reaches
boiling point, a further six
minutes will be needed to
sterilise the bottles. The
display will show the time
remaining in minutes.
o The appliance will beep
when nished. If the lid is
not removed, the bottles will
remain sterile for three hours
after sterilisation. The display
will show the time remaining in
hours. After three hours an "H"
will once more be displayed.
7. Remove the plug from the mains
socket. Carefully remove the lid.
Be careful as the steam under the
lid may be very hot.
8. Remove the bottles and
accessories from the appliance
using the bottle tongs. Wait for
a minimum of 20 minutes before
using the appliance again.
9. Dissemble the appliance and
clean all parts before storing. See
“Cleaning”.
NOTE: Never remove the lid when the
water is boiling.
NOTE: The appliance must only
be used with baby bottles that can
withstand boiling water.
STORAGE
• Ensure that the appliance is clean,
dry and completely cool before
storing it.
• Store the appliance in a clean and
dry place, for instance in its box.
