Bedienungsanleitung Melissa 637-006 (Seite 30 von 46) (Deutsch, Englisch, Dänisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

509396

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

Table 3: Guidance & Declaration - electromagnetic

immunity concerning Conducted RF & Radiated RF

Guidance&Declaration-Electromagneticimmunity

The models WL1 and WL3 are intended for use in the

electromagneticenvironmentspeciedbelow.Thecustomeror

the user should assure that it is used in such an environment.

Immunity

test

IEC

60601

test

level

Comp-

liance

level

Electromagnetic environment -

guidance

Portable and mobile RF

communicationsequipment

should be used no closer to

any part of the model WL1 and

WL3, including cables, than the

recommended separation distance

calculatedfromtheequation

applicabletothefrequencyofthe

transmitter.

Recommended separation

distance

Conducted

RFlEC

61000-4-6

Vrms

150

kHz

to 80

MHz

3V 3V

Radiated

RFlEC

61000-4-3

3 V/m

MHz

to2.5

GHz

3 V/m d=1.2×P

1/2

80MHzto800MHz

d=2.3×P

1/2

800MHzto2.5GHz

where P is the maximum output

power rating of the transmitter

In watts (W) according to the

transmitter manufacturer and d

Is the recommended separation

distance in meters (m).

FieldstrengthsfromxedRF

transmitters, as determined

by an electromagnetic site

survey,

should be less than

the compliance level in each

frequencyrange.

Interference may occur In the

vicinityofequipmentmarkedwith

thefollowingsymbol:

NOTEIAt80MHzend800MHz.thehigherfrequencyrange

applies.

NOTE 2 These guidelines may not apply in all situations.

Electromagnetic propagation is affected by absorption and

reectionfromstructures,objectsandpeople.

Fieldstrengthsfromxedtransmitters,suchasbasestations

for radio (cellular/cordless) telephones and land mobile radios,

amateur radio, AM and FM radio broadcast and TV broadcast

cannot be predicted theoretically with accuracy. To assess

theelectromagneticenvironmentduetoxedRFtransmitters,

an electromagnetic site survey should be considered. If the

measuredeldstrengthinthelocationinwhichthemodels

WL1 and WL3 are used exceeds the applicable RF compliance

level above, the models WL1 and WL3 should be observed to

verify normal operation. If abnormal performance is observed,

additional measures may be necessary, such as reorienting or

relocating the models WL1 and WL3.

Overthefrequencyrange150kHzto80MHz,eldstrengths

should be less than 3V/m.

Table 4: Recommended separation distances

between portable and mobile RF communications

equipment and the models WL1 and WL3

Recommended separation distances between

portableandmobileRFcommunicationsequipmentandthe

models WL1 and WL3

The models WL1 and WL3 are intended for use in

electromagnetic environment in which radiated RF disturbances

is controlled. The customer or the user of the models WL1

and WL3 can help prevent electromagnetic interference by

maintaining a minimum distance between portable and mobile

RFcommunicationsequipment(transmitters)andthemodels

WL1 and WL3 as recommended below, according to the

maximumoutputpowerofthecommunicationsequipment.

Rated maximum

output power

of transmitter

Separationdistanceaccordingtofrequency

of transmitter

150kHzto

80MHz

d=1.2×P

1/2

80MHzto

800MHz

d=1.2×P

1/2

800MHzto

2,5GHz

d=2.3×P

1/2

0.01 0.12 0.12 0.23

0.1 0.38 0.38 0.73

1 1.2 1.2 2.3

10 3.8 3.8 7.3

100 12 12 23

For transmitters rated at a maximum output power not listed

above, the recommended separation distance d in meters (m)

canbeestimatedusingtheequationapplicabletothefrequency

of the transmitter, where P is the maximum output power rating

of the transmitter in watts (W) accordable to the transmitter

manufacturer.

NOTEIAt80MHzand800MHz.theseparationdistanceforthe

higherfrequencyrangeapplies.

NOTE 2 These guidelines may not apply in all situations.

Electromagnetic propagation is affected by absorption and

reectionfromstructures,objectsandpeople.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Melissa 637-006 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info