Bedienungsanleitung Mellerware Omega - 22800 (Seite 4 von 26) (Englisch, Französisch, Portugiesisch, Spanisch)

799559

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

guarantee and the manufacturer’s

liability null and void.

3. Instructions for use

3.1. Before use:

3.1.1. Remove the appliance’s protective

film (if applicable).

3.1.2. Before using the product for

the first time, clean the parts that

will encounter water in the manner

described in the cleaning section.

3.2.1. Before using this product, please

make sure to carefully read this manual,

especially the “Safety Tips” section.

3.2.2. Open the kettle, then add the

water to the kettle and close the lid. To

prevent injury due to steam after boiling,

ensure water is place lower than the

minimum line and not higher than the

maximum line.

3.2.3. Insert the power plug into the

socket, then place the kettle on the base

and turn on the switch.

3.2.4. The kettle will automatically switch

off.

3.2.5. Before pouring the water, wait until

the water inside the kettle has stopped

the boiling process.

4. Cleaning and Maintenance

4.1. DESCALING: Always ensure that

the kettle is disconnected from the

mains before descaling. Scaling or

furring is a common problem in hard

water areas.

4.2. Fill the kettle to MAX position and

boil the water. Remove the kettle from

the power socket and the base unit and

place it in an empty sink or bowl.

4.3. Add 50 grams of Citric Acid

(available from chemists) or other

descaling products (available at

supermarkets) to the water or as

directed.

4.4. Leave it to stand for approximately

5 minutes or until the effervescence

subsides, and then empty the water.

Rinse thoroughly, and wipe.

5. Anomalies and repair

5.1. Take the appliance to an authorized

support centre if product is damaged or

other problems arise.

5.2. If the connection to the mains has

been damaged, it must be replaced, and

you should proceed as you would in the

case of damage.

6. Additional warnings for kettles

6.1. The kettle and base (where

applicable) must not be operated with

any other models of kettle.

6.2. The kettle is fitted with a dry

operation cut out that switches off the

kettle if it has boiled dry.

If this happens allow the kettle to cool

down for approximately 15 minutes, then

fill the kettle with

cold water. This will reset the cut out so

that the kettle can be used again.

6.3. Do not overfill. Check the water level

gauge when filling.

6.4. Ensure the lid is closed properly

before closed, to prevent water

splashing out when boiling.

Do not open the lid when boiling.

6.5. After the kettle has boiled it may

need a minute to cool down before

restarting.

6.6. Take care when pouring. Pour

slowly and do not over-tilt.

6.7. Make sure the kettle is always used

on a flat surface.

6.8. Water will remain hot for

considerable time after boiling and will

present a scalding hazard. Take care

and keep away from children.

6.9. The outside surface of the kettle will

become hot during use. To avoid injuries

only hold the

handle.

22800.indd 422800.indd 4 2021/06/09 14:482021/06/09 14:48

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mellerware Omega - 22800 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info