799552
6
Zoom out
Zoom in
Vorherige Seite
1/35
Nächste Seite
3.4.5.3. Hold the lter by the edges and “TAP CLEAN”
on a hard, at surface until the dust particles are
removed from between the pleats of the lter.
3.4.5.4. The HEPA type lter may also be washed with
lukewarm water by holding it under a running tap and
allowing the water to run on the dirty side. We recom-
mend washing it at least once a month depending on
how often you use it or when the suction appears to
reduce.
3.4.5.5. Always allow the lter to air dry for at least 24
hours before placing it back into the vacuum.
NB Ensure the lter is completely dry before placing
back into the vacuum.
3.4.5.6. Reinstall the lter into the dust cover and click
it back onto the dust bin.
Please Note that it is normal for the lter to discolor
over time, this will not affect the performance of the
lter.
3.4.6 Reinstalling the dust bin:
3.4.6.1. Ensure that the small intake air vent on the
dust bin is aligned with the opening on the main unit.
3.4.6.2. Slide the dust bin into place and push back
until you hear it lock into place.
CAUTION: The suction hole must be open and free of
any obstructions at all times. Otherwise, the motor will
overheat and could become damaged.
Warning: Always empty the dust bin container and
clean the HEPA type lter after each use and during
prolonged usage.
Never over ll the dust bin container, remove dirt and
clean the HEPA type lter when dirt in dust bin is at or
just below the “MAX” level during prolonged usage or
risk motor damage.
If you wash the HEPA type lter, ensure that it is com-
pletely air dry before inserting back in the vacuum.
Please Note: The HEPA type lter is washable. It
should, however, be replaced when damaged. Replace-
ment lters are available at Creative Housewares.
Contact details are below.
3.5 Once you have nished using the appliance:
3.5.1. Allow appliance to cool down.
3.5.2. Unplug the appliance from the mains power
supply.
3.5.3. Clean the appliance as described in the cleaning
section.
4. Cleaning
4.1. Clean the dust bin: when the dust bin is almost
on max, it is time to empty the dust cylinder. Open the
front cover by unclipping the dust cylinder lock. Take
out the bin and empty it.
4.2. Cleaning the HEPA type lter: once the dust bin is
removed un-clip the top handle to remove the HEPA
type lter. Please do not wash. The HEPA type lter
must be shaken to remove dust particles. This should
be done at least once a month.
4.3. Cleaning the air outlet lter: this is situated at the
back of the vacuum. Un-clip the back cover to remove
the air outlet lter. This should be washed at least
every six months. Allow to dry in the sun at least 24hrs
before using again(Ensure that the air outer lter is
properly dry before use).
NB: Please ensure that the lters are clean before
use. This will prolong the life of the motor.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
31100_IM.indd 6 06-Jul-17 11:28:32 AM
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mellerware Vortex - 31100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info