Bedienungsanleitung Mercedes 2010 R350 4MATIC (Seite 357 von 364) (Englisch)

584018

357

Zoom out

Zoom in

Vorherige Seite

1/364

Nächste Seite

immediately. If AdBlue

has crystallized

already, use cold water and a sponge.

AdBlue

residues will crystallize and soil

the affected surfaces.

High ambient temperatures

If AdBlue

in the reservoir heats up to above

122‡

(50†) for a long period of time, for

example due to direct sunlight, ammonia gas

vapors may escape when opening the

AdBlue

tank.

Warning!

When opening the filler cap of the AdBlue

tank ammonia gas vapors may escape. Refill

AdBlue

in a well ventilated area only.

Ammonia

gas vapors have a pungent odor and

are particularly irritating for your skin,

mucous membranes, and eyes. Inhaling

ammonia gas vapors will cause burning eyes,

nose, and throat, as well as coughing and

watering eyes.

Low ambient temperatures

AdBlue

freezes at a temperature of

approximately 12‡ (-11†). Your vehicle is

factory

equipped with an AdBlue

preheating

system. The vehicle can thus be operated at

temperatures below 12‡ (-11†).

Special additives

Only use AdBlue

complying with

ISO 22241. Do not add additives to

AdBlue

and do not dilute AdBlue

with

water.

Otherwise, the BlueTEC exhaust gas

aftertreatment system could be damaged.

Damage caused by using additives or

diluting with water are not covered by the

Mercedes-Benz Limited Warranty.

Purity

The purity of AdBlue

is of particular

importance for avoiding malfunctions in the

exhaust gas aftertreatment.

If AdBlue

is pumped out of the tank, e.g.

during repair work, the same liquid must not

be used to refill the tank as its purity is no

longer guaranteed.

Impurities caused for example by other

service

products, cleaning agents, and dust

result in increased emissions,

malfunctions, catalyst damage, or engine

damage.

Coolants

The engine coolant is a mixture of water and

anticorrosion/antifreeze, which provides:

Corrosion protection

Freeze protection

Boiling

protection (by increasing the boiling

point)

The cooling system was filled at the factory

with a coolant providing freeze protection to

approximately -35‡ (-37†) and corrosion

protection.

Add premixed coolant solution only.

Adding water and MB 325.0 Anticorrosion/

Antifreeze separately from each other,

could cause engine damage not covered by

the Mercedes-Benz Limited Warranty.

If the antifreeze mixture is effective to -35‡

(-37†), the boiling point of the coolant in the

pressurized cooling system is reached at

approximately 266‡ (130†).

The coolant solution must be used year round

to provide the necessary corrosion protection

and increase boil-over protection. Refer to

the Maintenance Booklet for replacement

interval.

Coolant system design and coolant used

determine the replacement interval. The

replacement interval published in the

Maintenance Booklet is only applicable if

MB 325.0 Anticorrosion/Antifreeze solution

or other Mercedes-Benz approved products

of equal specification are used to renew the

Fuels, coolants, lubricants, etc.

355

Technical data

251_AKB; 4; 52, en-US

d2ureepe, Version: 2.11.8.1

2009-03-23T09:22:52+01:00 - Seite 355

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes 2010 R350 4MATIC Seite 357

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info