Bedienungsanleitung Mercedes AMG GT 2018 (Seite 232 von 294) (Englisch)

703617

232

Zoom out

Zoom in

Vorherige Seite

1/294

Nächste Seite

Several attempts might be necessary. You

should test every position for at least

25 seconds before trying another position.

Synchronizing the rolling code

Pay attention to the "Important safety notes"

(

Y page 229).

If the garage door system uses a rolling code,

you will also have to synchronize the garage

door system with the integrated garage door

opener in the rear-view mirror. To do this you will

need to use the programming button on the door

drive control panel. The programming button

may be located in different places depending on

the manufacturer. It is usually located on the

door drive unit on the garage ceiling.

Familiarize yourself with the garage door drive

operating instructions, e.g. under "Program-

ming additional remote controls", before carry-

ing out the following steps.

Your vehicle must be within reach of the garage

door or gate opener drive. Make sure that nei-

ther your vehicle nor any persons/objects are

present within the sweep of the door or gate.

Select SmartKey position 2 with the Start/

Stop button (

Y page 106).

Get out of the vehicle.

Press the programming button on the door

drive unit.

You now have 30 seconds to initiate the next

step.

Get into the vehicle.

Press previously programed button ;, =

or ? on the integrated garage door opener

repeatedly until the door closes.

The rolling code synchronization is then com-

plete.

Notes on programming the remote con-

trol

Canadian radio frequency laws require a "break"

(or interruption) of the transmission signals

after broadcasting for a few seconds. Therefore,

these signals may not last long enough for the

integrated garage door opener. The signal is not

recognized during programming. Comparable

with Canadian law, some U.S. garage door open-

ers also feature a "break".

Proceed as follows:

if you live in Canada.

if you have difficulties programming the

garage door opener (regardless of where you

live) when following the programming steps.

Press and hold one of buttons ; to ? on the

integrated garage door opener.

After a short time, indicator lamp : lights up

yellow.

Release the button.

Indicator lamp : flashes yellow.

Press button B of garage door remote con-

trol A for two seconds, then release it for two

seconds.

Press button B again for two seconds.

Repeat this sequence on button B of remote

control A until indicator lamp : lights up

green.

When indicator lamp : lights up green: pro-

gramming is finished.

When indicator lamp

: fl

ashes green: pro-

gramming was successful. The next step is to

synchronize the rolling code.

Release button B of remote control A of the

garage door drive.

When indicator lamp : lights up red: repeat

the programming process for the correspond-

ing button on the rear-view mirror. When

doing so, vary the distance between remote

control A and the rear-view mirror.

The required distance between remote con-

trol A and the integrated garage door opener

depends on the garage door drive system.

Several attempts might be necessary. You

should test every position for at least

25 seconds before trying another position.

Problems when programming

If you are experiencing problems programming

the integrated garage door opener on the rear-

view mirror, take note of the following instruc-

tions:

Check the transmitter frequency used by

garage door drive remote control A and

whether it is supported. The transmitter fre-

quency can usually be found on the back of

remote control A for the garage door drive.

The integrated garage door opener is com-

patible with devices that have units which

230

Features

Stowage and features

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes AMG GT 2018 Seite 232

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mercedes AMG GT 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info