Bedienungsanleitung Mercedes C-Class Sedan 2015 (Seite 64 von 406) (Englisch)

624685

Zoom out

Zoom in

Vorherige Seite

1/406

Nächste Seite

All child restraint systems must meet the fol-

lowing standards:

U.S. Federal Motor Vehicle Safety Stand-

ards 213 and 225

Canadian Motor Vehicle Safety Standards

213 and 210.2

Confirmation that the child restraint system

corresponds to the standards can be found

on an instruction label on the child restraint

system. This confirmation can also be found

in the installation instructions that are inclu-

ded with the child restraint system.

Observe the warning labels in the vehicle inte-

rior and on the child restraint system.

LATCH-type (ISOFIX) child seat secur-

ing system

WARNING

LATCH-type (ISOFIX) child restraint systems

do not offer sufficient protective effect for

children whose weight is greater than 48 lbs

(22 kg) who are secured using the safety belt

integrated in the child restraint system. In the

event of an accident, a child might not be

restrained correctly. This poses an increased

risk of injury or even fatal injury.

If the child weighs more than 48 lbs (22 kg),

only use LATCH-type (ISOFIX) child restraint

systems with which the child is also secured

with the vehicle seat belt. Also secure the

child restraint system with the Top Tether

belt, if available.

Always comply with the manufacturer's

installation and operating instructions for the

child restraint system used.

Before every trip, make sure that the LATCH-

type (ISOFIX) child restraint system is

engaged correctly in both LATCH-type (ISO-

FIX) securing rings

When installing the child restraint system,

make sure that the seat belt for the middle

seat does not get trapped. The seat belt

could otherwise be damaged.

LATCH-type (ISOFIX) securing rings

Vehicles with rear seat armrest: adjust the

rear seat armrest so that LATCH-type (ISO-

FIX) securing rings : for the LATCH-type

(ISOFIX) child restraint system are accessi-

ble.

Install the LATCH-type (ISOFIX) child

restraint system on both LATCH-type (ISO-

FIX) securing rings :.

The LATCH-type (ISOFIX) system is a stand-

ardized securing system for specially

designed child restraint systems on the rear

seats. LATCH-type (ISOFIX) securing rings :

for two LATCH-type (ISOFIX) child restraint

systems are installed on the left and right rear

seats.

Non-LATCH-type (ISOFIX) child seats may

also be used and can be installed using the

vehicle's seat belt system. Install child seats

according to the manufacturer's instructions.

Top Tether

Introduction

Top Tether provides an additional connection

between the child restraint system secured

with a LATCH-type (ISOFIX) child seat mount

and the vehicle. This helps reduce the risk of

injury even further. If the child restraint sys-

tem is equipped with a Top Tether belt, this

should always be used.

Children in the vehicle

Safety

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes C-Class Sedan 2015 Seite 64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info