Bedienungsanleitung Mercedes C-Klasse Limousine 2014 (Seite 478 von 489) (Englisch)

817165

478

Zoom out

Zoom in

Vorherige Seite

1/489

Nächste Seite

Brake fluid

GWARNING

The brake fluid continuously absorbs mois-

ture from the air. This results in the boiling

point of the brake fluid lowering. If the boiling

point of the brake fluid is too low, vapour

pockets may form when the brakes are sub-

jected to a heavy load. This would impair brak-

ing efficiency. There is a risk of an accident.

Have the brake fluid renewed at the prescri-

bed intervals.

When handling brake fluid, observe the

important safety notes on service products

(Ypage 468).

The brake fluid change intervals can be found

in the Service Booklet.

Only use brake fluid approved by Mercedes-

Benz according to MB Approval 331.0.

Information about approved brake fluid can

be obtained at any qualified specialist work-

shop or on the Internet at

http://bevo.mercedes-benz.com.

iHave the brake fluid regularly replaced at

a qualified specialist workshop and the

replacement confirmed in the Service

Booklet.

Coolant

Important safety notes

GWARNING

If antifreeze comes into contact with hot com-

ponents in the engine compartment, it may

ignite. There is a risk of fire and injury.

Let the engine cool down before you top up

the antifreeze. Make sure that antifreeze is

not spilled next to the filler neck. Thoroughly

clean the antifreeze from components before

starting the engine.

!Only add coolant that has been premixed

with the desired antifreeze protection. You

could otherwise damage the engine.

Further information on coolants can be

found in the Mercedes-Benz Specifications

for Service Products, MB Specifications for

Service Products 310.1, e.g. on the Inter-

net at http://bevo.mercedes-benz.com.

Or contact a qualified specialist workshop.

!Always use a suitable coolant mixture,

even in countries where high temperatures

prevail.

Otherwise, the engine cooling system is not

sufficiently protected from corrosion and

overheating.

iHave the coolant regularly replaced at a

qualified specialist workshop and the

replacement confirmed in the Service

Booklet.

The coolant is a mixture of water and anti-

freeze/corrosion inhibitor. It is responsible

for the following:

Ranti-corrosion protection

Rantifreeze protection

Rraising the boiling point

If antifreeze/corrosion inhibitor is present in

the correct concentration, the boiling point of

the coolant during operation will be approx-

imately 130 †.

The antifreeze/corrosion inhibitor concentra-

tion in the engine cooling system should:

Rbe at least 50%. This will protect the engine

cooling system against freezing down to

approximately -37 †.

Rnot exceed 55% (antifreeze protection

down to -45 †). Heat will otherwise not be

dissipated as effectively.

Mercedes-Benz recommends an antifreeze/

corrosion inhibitor concentrate in accord-

ance with

MB Specifications for Service Products 310.1

The coolant is checked at every maintenance

interval at a qualified specialist workshop.

iWhen the vehicle is first delivered, it is fil-

led with a coolant mixture that ensures

Service products and capacities 475

Technical data

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes C-Klasse Limousine 2014 Seite 478

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mercedes C-Klasse Limousine 2014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info