Bedienungsanleitung Mercedes E-Class Sedan 2016 (Seite 286 von 350) (Englisch)

624587

286

Zoom out

Zoom in

Vorherige Seite

1/350

Nächste Seite

Notes on 4MATIC vehicles

Vehicles with 4MATIC must not be towed

with either the front or the rear axle raised,

as doing so will damage the transmission.

If the vehicle has transmission damage or

damage to the front or rear axle, have it trans-

ported on a transporter or trailer.

In the event of damage to the electrical

system

If the battery is defective, the automatic

transmission will be locked in position P. To

shift the automatic transmission to position

N, you must provide power to the vehicle's

electrical system in the same way as when

jump-starting (

Y page 279).

Have the vehicle transported on a transporter

or trailer.

Tow-starting (emergency engine

starting)

Vehicles with automatic transmission

must not be started by tow-starting. This

could otherwise damage the transmission.

You can find information on "Jump-start-

ing" under (

Y page 279).

Fuses

Important safety notes

WARNING

If you manipulate or bridge a faulty fuse or if

you replace it with a fuse with a higher amper-

age, the electric cables could be overloaded.

This could result in a fire. There is a risk of an

accident and injury.

Always replace faulty fuses with the specified

new fuses having the correct amperage.

Only use fuses that have been approved

for Mercedes-Benz vehicles and which

have the correct fuse rating for the system

concerned. Otherwise, components or sys-

tems could be damaged.

The fuses in your vehicle serve to close down

faulty circuits. If a fuse blows, all the compo-

nents on the circuit and their functions stop

operating.

Blown fuses must be replaced with fuses of

the same rating, which you can recognize by

the color and value. The fuse ratings are listed

in the fuse allocation chart.

If a newly inserted fuse also blows, have the

cause traced and rectified at a qualified spe-

cialist workshop, e.g. an authorized

Mercedes-Benz Center.

Before changing a fuse

Pay attention to the important safety notes

(

Y page 284).

Secure the vehicle against rolling away

(

Y page 151).

Switch off the engine.

Switch off all electrical consumers.

Remove the SmartKey from the ignition

lock.

or, on vehicles with KEYLESS‑GO:

Open the driver's door.

The on-board electronics now have status

0. This is the same as the SmartKey having

been removed.

The driver’s door can be closed again.

All indicator lamps in the instrument cluster

must be off.

The fuses are located in various fuse boxes:

Fuse box in the engine compartment on the

left-hand side of the vehicle, when viewed

in the direction of travel

Fuse box in the trunk/cargo compartment

on the right-hand side of the vehicle, when

viewed in the direction of travel

The fuse allocation chart is located in the

vehicle tool kit in the stowage compartment

under the trunk/cargo compartment floor

(

Y page 270).

284

Fuses

Roadside Assistance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes E-Class Sedan 2016 Seite 286

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info